Kenwood DPX501U Instruction Manual

Also see for DPX501U: Service manual

Contents

Kenwood DPX501U Instruction Manual Manual pdf 14 page image

14 | EnglishGeneral featuresSpeaker SettingFine-tuning so that the System Q value is optimalwhen setting the speaker type.1 Enter StandbyPress the [SRC] button.Select the "STANDBY" display.2 Enter Speaker Setting modePress the [VOL] knob."SP SEL"/ "SP" is displayed.3 Select the Speaker typeTurn the [VOL] knob.Each time you turn the knob, the settingalternates between the settings shown in thetable below.Speaker type DisplayOFF "OFF"/ "SP OFF"For 5 & 4 in. speaker "5/4 inch"/ "SP 5/4"For 6 & 6x9 in. speaker "6x9/6 inch"/ "SP 6*9/6"For the OEM speaker "O.E.M."/ "SP OEM"4 Exit Speaker Setting modePress the [VOL] knob.Audio SetupSetting the Sound system, such as Cross overNetwork.1 Select the source to adjustPress the [SRC] button.2 Enter Audio Setup modePress the [VOL] knob for at least 1 second.3 Select the Audio Setup item to adjustPress the [VOL] knob.Each time you press the knob, the item to beadjusted alternates between the items shown inthe table below.4 Setup the Audio itemTurn the [VOL] knob.Adjustment Item Display RangeFront High Pass Filter*2 "HPF-F Fc"/"HPF"Through/40/60/80/100/120/150/180/220 HzRear High Pass Filter* 2 "HPF-R Fc"/"HPR"Through/40/60/80/100/120/150/180/220 HzLow Pass Filter*1,2 "LPF-SW"/"LPF"50/60/80/100/120/Through HzSubwoofer Phase*1,2,3 "SW Phase"/"PHAS"Reverse (180°)/ Normal (0°)Volume offset "Vol-Offset"/"V-OFF"–8 — ±0Loudness "LOUD" OFF/ONDual Zone System "2 ZONE"/"2ZON"OFF/ON• Volume offset: Sets each source’s volume as adifference from the basic volume.• Loudness: Compensates for low and high tonesduring low volume.• *1 You can control this item when (page 37) is set to "SWPRE SW". (DPX501U only)• * 1 You can control this item when Output> (page 15) is set to "SW ON".• * 2 You can control this item when "2 ZONE"/ "2ZON" of

• * 3 You can control this item when Low Pass Filter is notset to Through.• Dual Zone SystemMain source and sub source (Auxiliary input) outputFront channel and Rear channel separately.- Set up the channel of sub source by System Setting> (page 37).- Select Main source by [SRC] button.- Adjust the volume of Front channel by [VOL] knob.- Adjust the volume of Rear channel by Control> (page 12).- The Audio Control has no effect on sub source.• You can use the Dual Zone System with the internalauxiliary input.5 Exit Audio Setup modePress the [VOL] knob for at least 1 second.