*AC Plug Adaptor (1) *(E03-0115-05)Use to adapt the plug on thepower cord to the shape of thewall outlet.(Accessory only for regions whereuse is necessary.)door antenna (1) Loop antenna (1) Remote control unit (1)Batteries (R6/AA) (2)V ideo cord (1)SCART plug adaptor (1)(Europe and U.K. only)(E69-0012-05)er cords (6)882-08) (A70-1607-08): KP(A70-1608-08): YX(A70-1609-08): ET(A70-1610-08): MM2H7265-08): RED7283-08): GREEN7284-08): BLUE7285-08): VIOLET7269-08): GREY7286-08): WHITE(T90-0896-08) (E30-1427-05)Caution on condensationCondensation (of dew) may occur inside the unit when there isa great difference in temperature between this unit and the out-side.This unit may not function properly if condensation occurs. Inthis case, leave the unit for a few hours, and restart the opera-tion after the condensation has dried up.Be specially cautious against condensation in a fol-lowing circumstances:When this unit is carried from one place to another across a largedifference in temperature, when the humidity in the room wherethis unit is installed increases, etc.Stored contents which arecleared in at least a week afterpower plug is unplugged frompower outlet.Amplifier sectionLast input selectionVolume control valueSurround settingACTIVE EQTuner sectionReceiving bandFrequencyPreset stationsTuning mode settingDVD sectionMenu setupPower statusMemory backup functionWARNING NOTICE:IN MOST CASES IT IS AN INFRINGEMENT OF COPY-RIGHT TO MAKE COPIES OF TAPES OR DISCS WITH-OUT THE PERMISSION OF THE COPYRIGHT OWN-ERS. ANYONE WISHING TO COPY COMMERCIALLYAVAILABLE TAPES OR DISC SHOULD CONTACT THEMECHANICAL COPYRIGHT PROTECTION SOCIETYLIMITED OR THE PERFORMING RIGHTS SOCIETY LIM-ITED.Note related to transportation and movementBefore transporting or moving this unit, carry out thefollowing operations.1 Remove the disc from the unit.2 Press the 6 key.3 Wait a few seconds and turn the unit OFF.Operation to resetThe microcomputer may fall into malfunction (impossibilityto operate, erroneous display, etc.) when the power cord isunplugged while power is ON or due to an external factor. Inthis case, execute the following procedure to reset themicrocomputer and return it to normal condition.÷ Please note that resetting the microcomputer clears thecontents stored in and returns and to condition when it leftthe factory.Set the POWER switch to ON (set to Standby mode).Then press the ¢ key, 4 key and STOP key in thisorder.The marking this product has been classified as Class1. It means that there is no danger of hazardous radia-tion outside the product.Location: Back panelCLASS 1LASER PRODUCTThe marking of products using lasers(Except for some areas)-6100/6100KCONTENTS / ACCESSORIES / CAUTIONSNTS / ACCESSORIES / CAUTIONS............. 2EMBLY FOR REPAIR....................................3DIAGRAM ......................................................4T DESCRIPTION ............................................5DIAGRAM ...................................................14PC BOARD .............................................................. 15SCHEMATIC DIAGRAM .......................................... 24EXPLODED VIEW ....................................................36PARTS LIST..............................................................37SPECIFICATIONS ......................................Back coverntssoriesns