Kenwood HD-7 Instruction Manual

Kenwood HD-7 Instruction Manual Manual pdf 43 page image

HD-7/EN43KnowledgeTuner sectionFor the U.S.A.Note to CATV system installerThis reminder is provided to call the CATV system installer's attention to Article 820-40 of the NECthat provides guidelines for proper grounding and, in particular, specifies that the cable ground shallbe connected to the grounding system of the building, as close to the point of cable entry as practical.In case of difficultySymptom Cause RemedyRadio stations cannot be received.Noise interferes.A station has been preset but it can-not be received by pressing the P.CALLkey.÷ The antennas have not been connected.÷ A proper broadcasting band has not beenselected.÷ The frequency of the station to be receivedis not tuned.÷ The space between radio channels is notsuitable for the area where you live.÷ Car ignition noise.÷ Influence of an electric appliance.÷ A TV set is installed near the system.÷ The frequency of the preset station is nottunable.÷ The preset memory has been cleared be-cause the power cord has been unpluggedfor a long period.÷ Connect antennas.÷ Select a band.÷ Tune to the frequency of the desired sta-tion.÷ Refer to "Channel space setting" and resetthe channel space.÷ Install the outdoor antenna in an apart posi-tion from the road.÷ Switch the suspected electric appliance OFF.÷ Install the TV or the system at an increaseddistance between them.÷ Preset stations with tunable frequencies.÷ Preset stations again.8™™£9££Remote control unitSymptom Cause RemedyRemote control operation is not pos-sible.÷ Batteries are exhausted.÷ The remote control is too far away from thesystem, the controlling angle is deviated orthere is an obstacle in between.÷ There is no CD set in the component to beplayed.÷ Replace with new batteries.÷ Operate the unit inside the remote control-lable range.÷ Set a CD in the component to be played.%%)RemedyCauseSymptomCD player÷ Place the disc properly, with the label sidefacing upward.÷ Place the disc properly.÷ Clean the disc referring to “Disc handlingprecautions”.÷ Try another disc.÷ Refer to “Caution on condensation” andremove the condensation by evaporation.÷ Place a disc in the CD player.÷ Press the CD 6 key.÷ Clean the disc referring to “Disc handlingprecautions”.÷ Try another disc.÷ Clean the disc referring to “Disc handlingprecautions”.÷ Try another disc.÷ Install the unit in a place not subject tovibrations.A CD is placed in the player but it can-not be played.Sound is not produced.Sound skips.÷ The disc is placed upside down.÷ The disc position is displaced.÷ The disc is extremely dirty.÷ The disc is scratched.÷ Dew is condensed on the optics lens.÷ The disc has not been placed.÷ The player is not put to the play mode.÷ The disc is extremely dirty.÷ The disc is scratched.÷ The disc is dirty.÷ The disc is scratched.÷ The player is subject to vibration.))q‚))qq

/ 44

Related manuals for Kenwood HD-7