7POWER INBATT P.CON(REMOTE)GND LEFTBRIDGEDRIGHTSPEAKER OUTPUT- +nPower and Speakers cable connectionPower control(REMOTE) lead terminalLeftspeakerRightspeakerConnect the ground cable to a metalpart of the car chassis that acts as anelectrical ground passing electricity tothe battery‘s negative - terminal. Donot turn the power on if the groundcable is not connected.NOTE• If a buzzing noise is heard from the speakers when the engine is running,connect a line noise filter (optional) to each of the battery cable.• Do not allow the cord to directly contact the edge of the iron plate by usingGrommets.Terminal coverFire wallGrommetsBatteryGround cable (Black)Battery cable (Yellow)Round terminal (Large)Power control cablePower terminalPass battery and ground cables through suppliedterminal cover and connect to respectiveterminals. After completing connections, fastenterminal cover over terminal bracket.POWER INBATT P.CON(REMOTE)GND LEFTBRIDGEDRIGHTSPEAKER OUTPUTRound terminal (Medium)Round terminal (Small)(Bridged)BridgedIf you wish to bridge-connect a speaker,the speaker impedance must be no lessthan 4 ohms.Connecting a speaker with an impedancelower than 4 ohms may damage the unit.examples:2CAUTION≥4ΩLR≥8Ω ≥8ΩLRSpeaker output cable terminalConnect the speaker outputcables to these terminals.Lead terminal(Commerciallyavailable part)Speaker outputcableTo prevent fire caused by a short in the wiring, connect afusible link or breaker nearby the battery’s positive terminal.2WARNING