Kenwood KAC-X11D Instruction Manual

Contents

EnglishP.CON SPEAKER OUTPUTREMOTEFUSE [30Ax3]GNDBATT.LINE IN LINE OUTLRTHERMAL MANAGEMENT PROTECTIONINPUTSENSITIVITY[V]ISFFREQUENCY[Hz]LPFFREQUENCY[Hz]0.2 [MAX]0.30.5200LINE OUTFILTERONOFF150100703540152025 30501234[MIN] 5 ZControlsRemote controller1 Fuse (0 A × )NOTEIf you can’t find the specified capacity fuse at your store etc., consult yourKenwood dealer.2 Battery terminal3 Power control terminalControls the unit ON/OFF.NOTEControls the unit power. Be sure to connect it with all the systems.4 Ground terminal5 Speaker output terminalsAs this unit accepts speakers with a minimum impedance of 1 ohm, connectspeakers with 1-ohm or higher impedance to these terminals.6 REMOTE terminalConnects the Remote cable.NOTEUse the Remote cable of the accessory.7 LINE IN terminal8 LINE OUT terminalThe audio signal set with the LINE OUT FILTER switch will be output.9 BOOST LEVEL (Bass boost level) controlSets the level by which the low frequency range should be boosted.0 Power indicator- FREQUENCY (Bass boost frequency) controlSets the center frequency around which the low frequency range should beboosted.= THERMAL MANAGEMENT indicatorLights this indicator when the internal temperature is high.~ PROTECTION indicatorLights this indicator when the protection function is activated. (See page 2)! Power indicatorWhen the power is turned on, the Power indicator lights.@ LPF(Low-Pass Filter) FREQUENCY controlThis control adjusts the frequency band output from this unit.# ISF (infrasonic filter) controlUltralow frequencies that cannot be reproduced even by a subwooferspeaker do not become sound but become unnecessary oscillations, whichaffect the sound by causing distortion, etc. Setting this control cuts thefrequencies below the respective frequency.This improves the reproduction performance of the speakers by eliminatingunnecessary oscillations which will not become sound.$ INPUT SENSITIVITY controlSet this control according to the pre-output level of the center unitconnected with this unit.NOTEFor the pre-output level, refer to the in the instructionmanual of the center unit.% LINE OUT FILTER switchChanging over the audio signal output to the LINE OUT terminal.ON position:The audio signal adjusted when setting LPF, INPUT SENSIVITY control andBass boost (optional accessory) is output to the LINE OUT terminal.OFF position:The audio signal input from the LINE IN terminal is output to the LINE OUTterminal (through output).CAUTIONThe volume of the audio output to the LINE OUT terminal is different in ONand OFF position. Remember this when changing the LINE OUT FILTER switchfrom ON to OFF.NOTEThe control panel locates under the front sidecover. Remove the cover to access to its controls foradjustment. (See page 3)

/ 8

Related manuals for Kenwood KAC-X11D