26 | KCA-BT200Troubleshooting GuideWhat might seem to be a malfunction in your unitmay just be the result of slight misoperation ormiswiring. Before calling service, first check thefollowing table for possible problems.? The hands-free talk volume is low.✔ The hands-free talk volume is set at a low level.☞ The hands-free talk volume can be adjustedindependently. Adjust it during hands-free talk.? No sound is heard from the rear speakers.✔ You are talking in the hand-free talk mode.☞ No sound is heard from the rear speakers in thehands-free talk mode.? No beep is heard at reception of an incoming call.✔ No beep is heard depending on the type of yourcell-phone.☞ The isset ON.? Voice is not recognized.✔ The vehicle window is open.☞ If the surrounding noise is large, voice cannot berecognized properly. Close the vehicle windowsto reduce noise.✔ Small voice.☞ If voice is too small, it cannot be recognizedproperly. Speak into the microphone a little moreloudly and naturally.✔ The person uttering the voice tag is not the one whoregistered the it.☞ Only the voice of the person who registered thevoice tag can be recognized.? The Bluetooth audio player cannot be registered(pairing).✔ The PIN code is fixed.☞ When a PIN code is specified in the InstructionManual for Bluetooth Audio Player, register itwith reference to toregister the Bluetooth audio player. If no PINcode is specified in the Instruction Manual, try“0000”.? The sound from the Bluetooth audio player isdiscontinuous.✔ The distance between this unit and audio player istoo far.☞ Move the audio player nearer to this unit.✔ Another Bluetooth device is affecting the Bluetoothcommunication.☞ Turn off another Bluetooth device.☞ Move another Bluetooth device away from thisunit.The messages shown below display yoursystems condition.No Number/ NO-NMBER/ Incoming No Number :• The calling party does not notify a caller ID.• There is no phone number data.InstallationInstallation the Bluetooth unit¤• Determine the installation position after making sure thatthe unit can communicate with the Bluetooth device.• Please do not install the unit near the dashboard, the reartray, or other important components. Doing so could leadto injury or accident should the unit come off due to ashock and strike a person or an important component.Tapping screws should be used for mounting. (Attachmentwith velcro strips, although easy, can come off with ashock.)Securing to audio boardSecuring to pile carpetAccessory 3Antenna part⁄• Do not stick the velcro tape over the serial number.• If the installation place is stepped, cut the velcro tape intotwo pieces and stick them at two positions.Antenna partAccessory 2 (Ø4 × 16 mm)
