Kenwood KCH-16 Service Manual

Also see for KCH-16: Instruction manual Brochure & specs

Contents

Kenwood KCH-16 Service Manual Manual pdf 14 page image

KCH-1614INSTALLATION1. Transceiver (TK-5710/5710H/5810/5810H)The KRK-16 Handheld control head is used to remotelyoperate the transceiver (TK-5710/5710H/5810/5810H).■ Using the transceiver with one KCH-16(For use with a single head)1-1. Installing the KRK-11 Panel assembly onto thetransceiver1. Remove the upper and lower cases of the transceiver.2. Insert the lead wire with connector (W700) from thetransceiver control unit (X53-412) to the connector (CN4)of the KRK-11 Panel assembly.3. Install the KRK-11 Panel assembly onto the transceiverusing four screws (q).Note:Take care that the lead wire with connector (W700) is notcaught when fitting the KRK-11 Panel assembly onto thetransceiver.TransceiverPackingW700CN4KRK-11Panel assembly ::Fig. 1-1-14. Affixing the sheet (G11-4379-04) for waterproofing (Fig.1-1-2).(1) Remove the cover paper from the sheet (w).(2) Affix the sheet while taking note of the position of thethree parts as shown in Fig.1-1-2 (e).Firmly affix the sheet to the chassis by pushing thedouble-coated tape with your fingers.(3) Repeat step (2) to affix the sheet to the other side ofchassis.Note:The sheet cannot be reused. Affix a new sheet whenyou removed the sheet.5. Reassemble the upper case and lower case of the trans-ceiver. (Refer to the TK-5710(B)/5710H(B) service manual(B51-8727-10) (pages 25 and 26) or the TK-5810(B) ser-vice manual (B51-8780-00) (page 23).)Note:Take care that the sheet (G11-4379-04) does not peel offwhen installing the upper/lower case.Affix the sheetwhile taking note of theposition of the three parts.@.KRK-11 Panel assemblyFig. 1-1-21-2. Connecting the KRK-11 Panel assembly andInterface box using the KCT-22 control cable1. Insert one connector of the control cable to the trans-ceiver (with KRK-11 Panel assembly) and the other to theKRK-11 Interface box.Connect each GND cable with each GND terminal of theKRK-11 Panel assembly and KRK-11 Interface box usingthe screw (q) supplied with the control cable.2. Secure the one connector of the control cable to theKRK-11 Panel assembly using two screws (w) accordingto the installation condition of the transceiver.3. Secure the control cable to the KRK-11 Panel assemblywith the cable fitting (J21-4354-04) and the two screws(e) supplied with the KRK-11.4. Secure the other connector of the control cable to theKRK-11 Interface box using two screws (r) in the sameway.A B C102S5849736TransceiverKCT-22Control cableKRK-11Interface boxCablefittingGNDKCH-16J2GNDKRK-11Panel assembly: ;:@.Fig. 1-2