Kenwood KDC-1018 Instruction Manual

Also see for KDC-1018: Service manual

Switch the frequency step used in seeks. The factory defaultsare 50 kHz for FM and 9 kHz for AM.Turn the power off.Hold down buttons #1 and #5, then turn the power back on.The frequency step settings will be changed to 200 kHz for FMand 10 kHz for AM.When you change the frequency step settings, all memorycontents will be erased.Returning Frequency Step Settings to Original Values:Repeat steps 1 and 2 above.NOTE21Frequency Step SettingAlso, if you make no input for 10 seconds, the name will bestored up to the point that you have entered, and the modeends.• You can assign names to up to 18 FM stations and 16 AMstations.• All the station names will be erased if you press the Resetbutton.• If you want to change the name of a station, first display thename of the station (following steps 1 to 4 above), then changethe letter(s) that you want by following steps 5 and 6.NOTEFunction of the KDC-4018/KDC-4018GYou can assign names to radio stations with the Station PresetMemory. Up to 18 FM stations and 16 AM stations can beassigned names.Adjust the frequency to the station whose name you want toenter.Enter the menu modePress the MENU button for at least one second. "MENU" isdisplayed when the menu mode is entered.Press the FM or AM button to select the display "NAME SET" .Press either the 4 or ¢ button for at least two seconds toenter the station name preset mode.The cursor will blink in the position where letters are entered.Press either the 4 or ¢ button to move the cursor to thedesired position.The 4 button moves the cursor to the left, and the ¢button to the right.Press the FM or AM button to display the desired character.Characters that can be displayed are as follows.Alphabet : A ~ ZNumerals and symbols : 0~9 @ " ‘ ` % & * + - = , . / \ < > [ ]Continue steps 5 and 6 until all the characters are chosen forthe name.You can enter up to eight characters for each name.Assigning NamesPress the MENU button.The name of the station is stored in memory, and the StationName Preset mode ends.8NOTE7654321Station Name Preset (SNPS)Recalling a Preset Station:Press the preset station button (#1-6) for the desired station.The number of the recalled station is displayed.— 13 —