Kenwood KDC-2092R Instruction Manual

Kenwood KDC-2092R Instruction Manual Manual pdf 26 page image

— 26 —EnglishTroubleshooting GuideWhat might seem to be a malfunction in your unit mayjust be the result of slight misoperation or miswiring.Before calling service, first check the following tablefor possible problems.General? The power does not turn ON.01✔ The fuse has blown.☞ After checking for short circuits in the wires, replace the fuse withone with the same rating.✔ No ACC position on vehicle ignition.02☞ Connect the same wire to the ignition as the battery wire.? Nothing happens when the buttons are pressed.04✔ The computer chip in the unit is not functioning normally.☞ Press the reset button on the unit (page 4).? There’s a source you can’t switch.06✔ There’s no CD inserted.☞ Set the media you want to listen to. If there’s no media in thisunit, you can't swhich to each source.? The memory is erased when the ignition is turned OFF.10✔ The battery wire has not been connected to the proper terminal.☞ Connect the wire correctly, referring to the section on.✔ The ignition and battery wire are incorrectly connected.11☞ Connect the wire correctly, referring to the section on.? The TEL mute function does not work.15✔ The TEL mute wire is not connected properly.☞ Connect the wire correctly, referring to the section on.? The TEL mute function turns ON even though the TEL mute wire isnot connected.16✔ The TEL mute wire is touching a metal part of the car.☞ Pull the TEL mute wire away from the metal part of the car.? Even if Loudness is turned ON, high-pitched tone isn't compensatedfor. 17✔ Tuner source is selected.☞ High-pitched tone isn't compensated for when in Tuner source.? No sound can be heard, or the volume is low.✔ The fader or balance settings are set all the way to one side.21☞ Center the fader and balance settings.✔ The input/output wires or wiring harness are connected incorrectly.22☞ Reconnect the input/output wires or the wiring harness correctly.See the section on .? The sound quality is poor or distorted.25✔ One of the speaker wires is being pinched by a screw in the car.☞ Check the speaker wiring.✔ The speakers are not wired correctly.27☞ Reconnect the speaker wires so that each output terminal isconnected to a different speaker.? The Touch Sensor Tone doesn’t sound.34✔ The preout jack is being used.☞ The Touch Sensor Tone can’t be output from the preout jack.? Even though Synchronize Clock is ON, the clock can’t be adjusted.35✔ The received RDS station isn’t sending time data.☞ Receive another RDS station.Tuner source? Radio reception is poor.39✔ The car antenna is not extended.☞ Pull the antenna out all the way.✔ The antenna control wire is not connected.40☞ Connect the wire correctly, referring to the section on.? It isn't the set Traffic information sound volume. 43✔ The set sound volume is less than the tuner sound volume.☞ If the tuner sound volume is louder than the set sound volume,thetuner sound volume is used.