Kenwood KDC-2092R Instruction Manual

Kenwood KDC-2092R Instruction Manual Manual pdf 3 page image

— 3 —To prevent injury and/or fire, take thefollowing precautions:• Insert the unit all the way until it is fullylocked in place. Otherwise it may fly out ofplace during collisions and other jolts.• When extending the ignition, battery orground wires, make sure to use automotive-grade wires or other wires with an area of0.75mm2 (AWG18) or more to prevent wiredeterioration and damage to the wirecoating.• To prevent short circuits, never put or leaveany metallic objects (e.g., coins or metaltools) inside the unit.• If the unit starts to emit smoke or strangesmells, turn off the power immediately andconsult your Kenwood dealer.• Make sure not to get your fingers caughtbetween the faceplate and the unit.• Be careful not to drop the unit or subject it tostrong shock.The unit may break or crack because itcontains glass parts.• Do not touch the liquid crystal fluid if theLCD is damaged or broken due to shock. Theliquid crystal fluid may be dangerous to yourhealth or even fatal.If the liquid crystal fluid from the LCDcontacts your body or clothing, wash it offwith soap immediately.2WARNINGTo prevent damage to the machine,take the following precautions:• Make sure to ground the unit to a negative12V DC power supply.• Do not open the top or bottom covers of theunit.• Do not install the unit in a spot exposed todirect sunlight or excessive heat or humidity.Also avoid places with too much dust or thepossibility of water splashing.• Do not set the removed faceplate or thefaceplate case in areas exposed to directsunlight, excessive heat or humidity. Alsoavoid places with too much dust or thepossibility of water splashing.• To prevent deterioration, do not touch theterminals of the unit or faceplate with yourfingers.• Do not subject the faceplate to excessiveshock, as it is a piece of precision equipment.• When replacing a fuse, only use a new onewith the prescribed rating. Using a fuse withthe wrong rating may cause your unit tomalfunction.• To prevent short circuits when replacing afuse, first disconnect the wiring harness.• Do not place any object between thefaceplate and the unit.• During installation, do not use any screwsexcept for the ones provided. The use ofimproper screws might result in damage tothe main unit.2CAUTION IMPORTANT INFORMATIONAbout the disc changer to beconnected:To connect a disc changer having the "O-N"switch to this unit, set the "O-N" switch to "N".To connect a disc changer having no "O-N"switch to this unit, the converter cord CA-DS100 and/or switching adapter KCA-S210Aare required as options.A disc changer doesn't work when it isconnected without using these options.If a model with no "O-N" switch is connected,some unavailable functions and informationthat cannot be displayed are generated.Note that none of the KDC-C100, KDC-C302,C205, C705, and non-Kenwood CD changerscan be connected.You can damage both your unit and the CDchanger if you connect them incorrectly.Do Not Load 8-cm (3-in.) CDs in the CDslotIf you try to load an 8-cm CD with its adapterinto the unit, the adapter might separate fromthe CD and damage the unit.Safety precautions