Kenwood KDC-4051UM Instruction Manual

Contents

Kenwood KDC-4051UM Instruction Manual Manual pdf 6 page image

6Getting startedCanceling the displaydemonstrationThe display demonstration is always turnedon unless you cancel it.When you turn on the power (or after youreset the unit), the display shows:[CANCEL DEMO] \ [PRESS] \[VOLUME KNOB]1 Press the volume knob.[YES] is selected as the initial setup.2 Press the volume knob again to confirm.[DEMO OFF] appears.If no operation is done for about15 seconds or if you turn the volume knobto select [NO] in step 2, [DEMO MODE]appears and the display demonstrationstarts.Setting the demonstration mode1 Press the volume knob to enter[FUNCTION].2 Turn the volume knob to select[DEMO MODE], then press to enter.3 Turn the volume knob to select [ON] or[OFF].If [ON] is selected, display demonstrationstarts if no operation is done for about20 seconds.4 Hold to finish the procedure.Adjusting the clock1 Press the volume knob to enter[FUNCTION] mode.2 Turn the volume knob to select[SETTINGS], then press to enter.3 Turn the volume knob to select [CLOCK],then press to enter.4 Turn the volume knob to select [CLOCKADJUST/ CLOCK ADJ], then press toenter.Clock hour flashes on the display.5 Turn the volume knob to adjust thehour, then press to enter the minuteadjustment.Clock minutes flashes on the display.6 Turn the volume knob to adjust theminute, then press to confirm.Press 4 / ¢ to move between thehour and minute adjustment.7 Hold to finish the procedure.Initial settings before operations1 Press SRC to enter [STANDBY] mode.2 Press the volume knob to enter[FUNCTION] mode.3 Turn the volume knob to select[INITIAL SET], then press to enter.4 Turn the volume knob to make aselection, then press to confirm.See table on page 7 for selection.5 Hold to finish the procedure.MaintenanceCleaning the unit: Wipe off the dirt on thepanel with a dry silicon or soft cloth. Failureto observe this precaution may result indamage to the monitor or unit.Cleaning the connector: Wipe off dirt onthe connector of the unit and faceplate.Use a cotton swab or cloth.Handling discsDo not touch the recording surface of thedisc.Do not stick tape etc. on the disc, or use adisc with tape stuck on it.Do not use any accessories for the disc.Clean from the center of the disc andmove outward.Clean the disc with a dry silicon or softcloth. Do not use any solvents.When removing discs from this unit, pullthem out horizontally.Remove the rims from the center holeand disc edge before inserting a disc.