A red indicator blinks on the unit after the faceplate isremoved, warning potential thieves.Display and setting:"DSI ON" : The disabled system indicator is on. (Default setting)"DSI OFF" : The disabled system indicator is off.Disabled System Indicator (DSI)With automatic time adjustment, you can set the clock timeautomatically according to time data sent from RDS stations(after receiving RDS signals for several minutes). You can alsoset the time manually if the automatic time adjustmentfunction is turned off.Display and setting:"SYNC ON" : Automatic time adjustment (Default setting)"SYNC OFF" : Manual time adjustmentAdjusting Time Automatically:Tune into an RDS station for 3 or 4 minutes.The time adjusts automatically to the correct local time.The time is not adjusted when the RDS station you are tuned tois not transmitting a time signal. Choose another RDS station insuch a case.NOTEAutomatic Time AdjustmentAdjust the time manually.This adjustment is available only when the automatic timeadjustment is set to off.Display and setting:Select the display "CLK ADJ" during the selecting function inthe menu system.Hold down either the 4 or ¢ button for two seconds ormore to enter the Manual time adjustment mode.The time display will blink.• Adjusting the hoursPress the FM button to advance the hours, or press the AMbutton to make the hours go back.• Adjusting the minutesPress the ¢ button to advance the minutes, or press the4 button to make the minutes go back.Press the MENU button to end the Manual Time Adjustmentmode.Exiting the Manual Time Adjustment mode would start theclock counting.4321NOTEManual Time AdjustmentThis function produces a beep sound that accompanies buttonoperation. It can be switched on or off.Display and setting:"BEEP ON" : Beep setting is on. (Default setting)"BEEP OFF" : Beep setting is off.The beep sound is not output from the preout jacks.NOTETouch Sensor Tone— 23 —