Kenwood KDC-4757SD Instruction Manual

Contents

12 INSTALLATION / CONNECTIONDo the requiredwiring. (➜ 13)Dashboard ofyour carBend the appropriate tabs to holdthe mounting sleeve firmly in place.How to remove the unit1 Detach the faceplate.2 Fit the catch pin on the extractionkeys into the holes on both sides ofthe trim plate, then pull it out.3 Insert the extraction keys deeply intothe slots on each side, then followthe arrows as shown on the right.Installating the unit (in-dash mounting)Warning• The unit can only be used with a 12 V DC power supply, negativeground.• Disconnect the battery’s negative terminal before wiring andmounting.• Do not connect Battery wire (yellow) and Ignition wire (red) to the carchassis or Ground wire (black) to prevent a short circuit.• Insulate unconnected wires with vinyl tape to prevent a short circuit.• Be sure to ground this unit to the car’s chassis again after installation.Caution• For safety’s sake, leave wiring and mounting to professionals. Consultthe car audio dealer.• Install this unit in the console of your vehicle. Do not touch the metalparts of this unit during and shortly after use of the unit. Metal partssuch as the heat sink and enclosure become hot.• Do not connect the · wires of speaker to the car chassis, Ground wire(black), or in parallel.• Mount the unit with the angle of 30º or less.• If your vehicle wiring harness does not have the ignition terminal,connect Ignition wire (red) to the terminal on the vehicle’s fuse boxwhich provides 12 V DC power supply and is turned on and off by theignition key.• After the unit is installed, check whether the brake lamps, blinkers,wipers, etc. on the car are working properly.• If the fuse blows, first make sure the wires are not touching car’schassis, then replace the old fuse with one that has the same rating.Basic procedure1 Remove the key from the ignition switch, thendisconnect the · terminal of the car battery.2 Connect the wires properly.See Wiring connection. (➜ 13)3 Install the unit to your car.See Installing the unit (in-dash mounting).4 Connect the · terminal of the car battery.5 Reset the unit. (➜ 3)Hook on the top sideOrientate the trim plate asillustrated before fitting.

/ 15

Related manuals for Kenwood KDC-3657SD