Kenwood KDC-515S Instruction Manual

Also see for KDC-515S: Instruction manual Service manual

Kenwood KDC-515S Instruction Manual Manual pdf 16 page image

Continue steps 3 and 4 until all the characters are chosen forthe name.You can enter up to 8 characters for each name.Assigning NamesPress the NAME.S button on the unit or the OK button on theremote.The name of the station is stored in memory, and the StationName Preset mode ends.Also, if you make no input for 10 seconds, the name will bestored up to the point that you have entered, and the modeends.• You can assign names to up to 32 FM stations and 16 AMstations.• All the station names will be erased if you press the RESETbutton.• If you want to change the name of a station, first display thename of the station (following steps 1 and 2 above), thenchange the letter(s) that you want by following steps 3 and 4.NOTE6NOTE5Button to press # Times pressedCharacter#3 11#2#6 2#2 3#3 2“D”“A”“N”“C”“E”You can assign names to radio stations with the Station PresetMemory. Up to 32 FM stations and 16 AM stations can beassigned names.Adjust the frequency to the station whose name you want toenter.The station name preset function cannot be used when aprogram service name or radio text is displayed.Press the NAME.S button for at least two seconds."NAME SET" is displayed once the station name preset modeis entered.The cursor will blink in the position where letters are entered.Press either the 4 or ¢ button to move the cursor to thedesired position.The 4 button moves the cursor to the left, and the ¢button to the right.You can also move the cursor left or right by pressing the 4or ¢ buttons, respectively, on the remote.Each time the 38 button is pressed, the characters to beentered change as listed below.Press the FM or AM button to display the desired character.Characters that can be displayed are as follows.Direct Alphabet InputDirect input can be made of letters (alphabetical) with the letterentry buttons on the remote.Example: Use the following table to enter the name "DANCE".NOTEAlphabet (upper case): A ~ ZAlphabet (lower case): a ~ z (KDC-X615/6015 Only)Numerals and symbols: 0~9 @ ” ‘ ` % & * + - = , . / \ < > [ ]Special characters: á à é è í ì ó ò ú ù Ñ Ç ® ß ‹ flâ ä ê ë î ï ô ö û ü ñ ç © Æ › fi(KDC-X615/6015 Only)432NOTE1Station Name Preset (SNPS)Tuner features— 16 —English