Kenwood KDC-BT30 Instruction Manual

Also see for KDC-BT40U: Service manual

English | 37The messages shown below display yoursystems condition.TOC ERROR: • No disc has been loaded in the discmagazine.• The CD is quite dirty. The CD is upside-down. The CD is scratched a lot.ERROR 05: The disc is unreadable.ERROR 77: The unit is malfunctioning for some reason.➪ Press the reset button on the unit. If the“ERROR 77” code does not disappear,consult your nearest service center.IN (Blink): The CD player section is not operatingproperly.➪ Reinsert the CD. If the CD cannot beejected or the display continues to flasheven when the CD has been properlyreinserted, please switch off the powerand consult your nearest service center.PROTECT (Blink):The speaker wire has a short-circuit ortouches the chassis of the vehicle, and thenthe protection function is activated.➪ Wire or insulate the speaker cableproperly and press the reset button. Ifthe “PROTECT” code does not disappear,consult your nearest service center.NA FILE: An Audio file is played with a format that thisunit can’t support.COPY PRO: A copy-protected file is played.READ ERROR: The file system of the connected USB deviceis broken.➪ Copy the files and folders for the USBdevice again. If the error message is stilldisplayed, initialize the USB device or useother USB devices.NO DEVICE: The USB device is selected as a sourcealthough no USB device is connected.➪ Change the source to any source otherthan USB. Connect an USB device, andchange the source to USB again.N/A DEVICE: • An unsupported USB device is connected.• Connection to the iPod has failed.➪ Check that the connected iPod is an iPodthat is supported. See (page 28) for information on supportediPods.NO MUSIC DATA/ERROR 15:• The connected USB device contains noplayable audio file.• Media was played that does not have datarecorded that the unit can play.USB ERROR: Some trouble may have occurred to theconnected USB device.➪ Remove the USB device, then cycle thepower switch to ON. If the same display isrepeated, use another USB device.iPod ERROR: Connection to the iPod has failed.➪ Remove the USB device and thenreconnect it.➪ Confirm that the software for the iPod isthe latest version.USB REMOVE (Blink):The Remove mode has been selected for theUSB device/iPod. You can remove the USBdevice/iPod safely.NO NUMBER: • The calling party does not notify a caller ID.• There is no phone number data.NO DATA: • There is no outgoing call list.• There is no incoming call list.• There is no missed call list.• There is no phone book list.NO ENTRY: The cell-phone has not been registered(pairing).HF DISCONCT: The unit cannot communicate with the cell-phone.HF ERROR 07: The memory cannot be accessed.➪ Turn off the power and on again. If thismessage still appears, press the resetbutton on the control unit.HF ERROR 68: The unit cannot communicate with the cell-phone.➪ Turn off the power and on again. If thismessage still appears, press the resetbutton on the control unit.UNKNOWN: The Bluetooth device cannot be detected.DEVICE FULL: 5 Bluetooth device have already beenregistered. No more Bluetooth device cannotbe registered.PIN CODE NG: The PIN code is wrong.CONNECT NG: The unit cannot be connected to the device.PAIRING NG: Pairing error.

/ 40

Related manuals for Kenwood KDC-BT40U