Kenwood KDC-BT43U Instruction Manual

Also see for KDC-BT33U: Manual Instruction manual

Contents

Kenwood KDC-BT43U Instruction Manual Manual pdf 4 page image

2CONTENTS BEFORE USEWarningDo not operate any function that takes your attention away from safe driving.CautionVolume setting:• Adjust the volume so that you can hear sounds outside the car to prevent accident.• Lower the volume before playing digital sources to avoid damaging the speakers by the sudden increase of theoutput level.General:• Avoid using the USB device or iPod/iPhone if it might hinder driving safety.• Make sure all important data has been backed up. We shall bear no responsibility for any loss of recorded data.• Never put or leave any metallic objects (such as coins or metal tools) inside the unit, to prevent a short circuit.• If a disc error occurs due to condensation on the laser lens, eject the disc and wait for the moisture to evaporate.• USB rating is indicated on the main unit. To view, detach the faceplate.Remote control (RC-406):• Do not leave the remote control in hot places such as on the dashboard.• The Lithium battery is in danger of explosion if replaced incorrectly. Replace it only with the same or equivalenttype.• The battery pack or batteries shall not be exposed to excessive heat such as sunshine, fire or the like.• Keep battery out of reach of children and in original package until ready to use. Dispose of used batteriespromptly. If swallowed, contact a physician immediately.2BEFORE USE 2BASICS 3GETTING STARTED 4RADIO 5CD / USB / iPod 6AUX 7BLUETOOTH® 8DISPLAY SETTINGS 11AUDIO SETTINGS 12MORE INFORMATION 13TROUBLESHOOTING 13SPECIFICATIONS 15INSTALLATION / CONNECTION 16How to read this manual• Operations explained mainly using buttonson the faceplate.• [XX] indicates the selected items.• (➜ XX) indicates references are available onthe stated page number.MaintenanceCleaning the unit: Wipe off dirt on the faceplate with a dry silicon or soft cloth.Cleaning the connector: Detach the faceplate and clean the connector with acotton swab gently, being careful not to damage the connector.Handling discs:• Do not touch the recording surface of the disc.• Do not stick tape etc. on the disc, or use a disc with tape stuck on it.• Do not use any accessories for the disc.• Clean from the center of the disc and move outward.• Clean the disc with a dry silicon or soft cloth. Do not use any solvents.• When removing discs from this unit, pull them out horizontally.• Remove burrs from the center hole and disc edge before inserting a disc.Connector (on the reverseside of the faceplate)