ENGLISH 31Part list for installation(A) Faceplate (×1) (B) Trim plate (×1)(C) Mounting sleeve (×1) (D) Wiring harness (×1)(E) Extraction key (×2) (F) ScrewsM5 × 7 mm (×4)M5 × 6 mm (×4)M4 × 8 mm (×1)Basic procedure1 Remove the key from the ignition switch, then disconnect theterminal of the car battery.2 Connect the wires properly.See “Wiring connection” on page 32.3 Install the unit to your car.See “Installing the unit (in-dash mounting)”.4 Connect the terminal of the car battery.5 Press B SRC to turn on the power.6 Detach the faceplate and reset the unit within 5 seconds.(Page 3)INSTALLATION/CONNECTIONInstalling the unit (in-dash mounting)Installing the unit (without mountingsleeve)1 Remove the mounting sleeve and trim plate fromthe unit.2 Align the holes in the unit (on both sides) with thevehicle mounting bracket and secure the unit withscrews (supplied).Use only the specified screws. Using wrong screwsmight damage the unit.Removing the unit1 Detach the faceplate.2 Fit the catch pin on the extraction keys into theholes on both sides of the trim plate, then pull itout.3 Insert the extraction keys deeply into the slots oneach side, then follow the arrows as shown on theillustration.Bend the appropriate tabs to hold thesleeve firmly in place.Hook on the top sideOrientate the trimplate as illustratedbefore fitting.Dashboard ofyour carDo the required wiring.(Page 32)