Kenwood KDC-BT752HD Instruction Manual

26 EnglishFunction settings1 Press SRC to select a source other than “STANDBY”.2 Press the volume knob to enter [FUNCTION] mode.3 Turn the volume knob to select [AUDIO CONTROL] or [SETTINGS], then press to enter.4 Turn the volume knob to make a selection, then press to confirm.■■ See table below for selection.■■ Repeat step 4 until the desired item is selected/activated.■■ Press to return to the previous item.5 Hold to finish the procedure.[AUDIO CONTROL] : While listening to any source except in STANDBY state or Bluetooth mode.Item Selectable setting (Preset: *)SUB-W LEVEL –15 — 0 * — +15: Adjusts the subwoofer output level.BASS LEVEL –8 — 0 * — +8: Source tone memory: Adjusts the level to memorize in each source. (Before making anadjustment, select the source you want to adjust.)MID LEVELTRE LEVELEQ PRO KDC-X796 onlyBASS ADJUST BASS CTR FRQ 60/ 80/ 100 */ 200: Selects the center frequency.BASS LEVEL –8 — 0 * — +8: Adjusts the level.BASS Q FACTOR 1.00 */ 1.25/ 1.50/ 2.00: Adjusts the quality factor.BASS EXTEND ON: Turns on the extended bass. ; OFF *: Cancels.MID ADJUST MID CTR FRQ 0.5K/ 1.0K */ 1.5K/ 2.5K: Selects the center frequency.MID LEVEL –8 — 0 * — +8: Adjusts the level.MID Q FACTOR 0.75/ 1.00 */ 1.25: Adjusts the quality factor.TRE ADJUST TRE CTR FRQ 10.0K/ 12.5K */ 15.0K/ 17.5K: Selects the center frequency.TRE LEVEL –8 — 0 * — +8: Adjusts the level.PRESET EQ NATURAL */ USER/ ROCK/ POPS/ EASY/ TOP40/ JAZZ/ POWERFUL: Selects a preset sound mode suitableto the music genre. (Selects [USER] to use the customized bass, middle, and treble settings.)BASS BOOST B.BOOST LV1/ B.BOOST LV2/ B.BOOST LV3: Selects your preferred bass boost level. ; OFF *: Cancels.LOUDNESS LOUDNESS LV1 */ LOUDNESS LV2: Selects your preferred low and high frequencies boost to produce a well-balanced sound at a low volume level. ; OFF: Cancels.BALANCE L15 — 0 * — R15: Adjusts the left and right speaker output balance.FADER R15 — 0 * — F15: Adjusts the rear and front speaker output balance.SUBWOOFER SET ON *: Turns on the subwoofer output. ; OFF: Cancels.DETAILED SETHPF THROUGH *: All signals are sent to the front speaker. ;100/ 120/ 150 (HZ): Frequencies lower than the specified value are cut off.LPFSUBWOOFERTHROUGH *: All signals are sent to the subwoofer. ;85/ 120/ 160 (HZ): Frequencies higher than the specified value are cut off.SUB-W PHASE REVERSE (180°)/ NORMAL (0°) *: Selects the phase angle of the subwoofer output to be in line with thespeaker output for optimum performance. (Selectable only if a setting other than [THROUGH] is selected for[LPF SUBWOOFER].)