(No.WA020)15/244.1.2.2 Attached table 2: CD information display mode4.1.2.3 Initialization of settings related to AUDIO setup• When [!] key is pressed briefly in STANDBY source, AUDIO settings are reset to their default values in the test mode.4.1.2.4 Others• In turning on this unit in the test mode, change LINE MUTE inhibit period of time from 10s to 1s.• In the test mode, do not write the DC offset error detection information in E2PROM even if the error is detected.• In the test mode, do not record contents of the backup memory in E2PROM even if the prescribed period of time is elapsed.• Do not run DEMO mode in the following modes: Test mode, Backup/Installer memory & CD mechanism information & service infor-mation & DC offset error detection information & BT memory information clear mode, or DC offset error detection information clearmode.Also, in the above mode, do not display DEMO ON/OFF switching items in the Menu list.[#$]*Press thiskey brieflyPress this key briefly: Transition to CD information display mode[Rotary](Counterclockwise)↑↓[Rotary](Clockwise)I2C communication condition & CD mechanism error log display[Image of display](In the " ", "OK" or "NG" shall be displayed. “ " shall display "- -" or "error code".)CD load error information display[Image of display](In the "xx", the number of Load Error shall be displayed. The maximum value is 99 and it indicates the number ofLoad Error)CD Eject error information display[Image of display](In the "xx", the number of Eject Error shall be displayed. The maximum value is 99 and it indicates the number ofEject Error)CD time code false count information display (Count skipping)[Image of display](In the "xx", the number of Count Lose shall be displayed. The maximum value is 99 and it indicates the number ofCount Lose)CD time code false count information display (Count not updated)[Image of display](In the "xx", the number of Count Stay shall be displayed. The maximum value is 99 and it indicates the number ofCount Stay)[#$] When this key is pressed briefly: CD information display mode is turned OFF (Recover).[Audio]When this key is pressed briefly: Invalid (It does not cause any operation)When this key is pressed and held: All of CD information is cleared. (Press and hold this key for 2 seconds while theservice information is being displayed)I2C _ _ _ _ _ _ _ _ _ _ _ _ _ERR _ 1- , 2- , 3-L o a d _ E r r o r _ _ _ __ _(1) x x_ _(2) x xE j e c t _ E r r o r _ _ _ __ _(1) x x_ _(2) x x_ _(3) x x_ _(4) x xC o u n t _ L o s e_ _CDDA _ : x x_ _CDROM : x xC o u n t _ S t a y_ _CDDA _ : x x_ _CDROM : x x
