(No.WA020)22/244.1.12 Forced Update functionTransit to appropriate mode by Reset and BU ON operation while [SEARCH MODE] key and [#$] key are pressed.After entering this mode, make the normal SRC feed with the [SRC] key or DISC insertion.The display of SRC switching and that of Reading are shown in the same manner as the display of the normal mode.After the completion of Reading, start the Update if there is an update file.If there is no update file, display “No File”.4.2 INSTALLER MEMORY SPECIFICATIONSAt specialists (or specialty stores), when the installer sends the vehicle back to the user, they may make the store-recommended audio con-figuration.When the user changes the setting values, when the backup power supply was taken out at times of battery change or when the reset buttonwas pressed, to make it possible to recall the setting values, the store-recommended configuration values can be saved into E2PROM.The specification detail defer in “with-DSP model” and in “without-DSP model”.[Models with DSP]• Calling and saving the configuration is done by the multifunction key. ([Preset1])• Items to be saved are Cabin, Position, Speaker, EQ, X'over, D.T.A., and Sub Woofer Level. Only one setting can be saved for each item.(EQ setting can be changed for each source, but only one setting can be saved as the installer memory specification, and the source inwhich the saving operation was carried out is saved as such.)Also, the setting value of Manual Position will be memorized for the setting values for all Preset Positions. (6 speakers x4)• The contents read out by the call key shall be reflected only to the current source at the time. → EQ curve is “USER”. (EQ setting can bechanged for each source, but not reflected to EQ settings of sources other than where the calling operation was carried out.)• When the backup power supply was taken out at times of battery change or when the reset button was pressed, as the initial setting valuesof Cabin, Position, Speaker, EQ, X'over, D.T.A., and Sub Woofer Level, the saved memory is reflected (EQ setting initial setting value mem-ory is reflected in all sources).NOTE: By such, EQ curve initial setting shall always be “USER”. (NOT “NATURAL” or “FLAT”.)Procedure Display DescriptionWith disc:Reset and BU On operation while[SEARCH MODE] key and [#$]key are pressed(Lights ON display)No disc:Reset and BU On operation while[SEARCH MODE] key and [#$]key are pressedReading(The display blinks)F / W U p d a t e 0 1 . 0 0F i l e C h e c kF / W U p d a t e 0 1 . 0 0R e a d i n gSRCDisc insertionAfter the SRC switches, the “Reading” is dis-played during reading(The display blinks)Update fileNot available(Lights ON display)Update fileAvailable, Update being performed(The display blinks)Progress displayed in 0~100(%).(Lights ON display)Update completed without error(Lights ON display)Update with Error(Lights ON display)F / W U p d a t e 0 1 . 0 0R e a d i n gF / W U p d a t e 0 1 . 0 0N o F i l eF / W U p d a t eU p d a t i n g5 7%F / W U p d a t eC o m p l e t e dF / W U p d a t eU p d a t e E r r o r
