Kenwood KDC-C467FM Instruction Manual

Also see for KDC-C467FM: Service manual Instruction manual Instruction manual

Contents

Kenwood KDC-C467FM Instruction Manual Manual pdf 13 page image

— 13 —Dynamic controlThe unit comes with the prevention of distortion function toreduce sound distortion.If the sound is distorted severely, press the + button on thedisplay unit and then set the function to "2" (ON). If theprevention of distortion function is set to "2" (ON), the soundextension is reduced.The initial setting is "1" (OFF).If a disc with a high recording level is used, the sound maydistort even if the prevention of distortion function is set to "2"(ON). In this case, reduce the modulation level.To cancel :Press the RDM button on the display unit for at least threeseconds.The LEVEL indicator will go off and the modulation levelchange will take effect. The control mode is automaticallycanceled if you do nothing for 15 seconds.2CAUTIONNOTETo set the control modePress the RDM button on the display unit for at least threeseconds.The LEVEL indicator will light up and the currently setmodulation level will be displayed.• If this function is on, the functions other than power on / off,reset, and changing the transmission frequency, cannot beoperated.• This function is not available when the random play, repeat play,or scan play function is on. Before using this function, cancelthe other functions. This function cannot be used while loadinga disc (while the play indicator is blinking).To change the modulation levelPress either the 4 or ¢ button.Each time the 4 or ¢ button is pressed, the modulationlevel changes in the range from 1 to 4. As the numberincreases, the modulation level increases.The initial setting is 2.2NOTE1Modulation level / Dynamic controlL E V E LModulation levelNumber for prevention ofdistortion setting