Kenwood KDC-C467FM Instruction Manual

Also see for KDC-C467FM: Service manual Instruction manual Instruction manual

Contents

Kenwood KDC-C467FM Instruction Manual Manual pdf 18 page image

— 18 —Troubleshooting guideWhat might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Beforecalling service, first check the following table for possible problems.SOLUTIONPOSSIBLE CAUSEPROBLEMPower button is not turned ON. Turn the power button ON.No sound or sound is low.The unit does not work properlywhen a button is pressed.The input/output wire or wiring harness is connectedincorrectly.Connect the input/output wire or wiring harness correctly.See "Connecting Wires to Terminals" (Page 15).The microcomputer malfunctions. Press the Reset button of the display unit.CD play does not start. CD auto-changer input is not connected to the unit. Connect the CD auto-changer input to the unit.The number of the slot into which the disc is inserted isdifferent from the number of the specified disc.Eject the disc magazine and check the number of thespecified disc.The specified disc is notplayed; a different disc isplayed instead.The specified disc is very dirty. Check and, if possible, clean the disc.See "Cleaning CDs" (Page 6).The disc is loaded upside down. Eject the disc magazine and insert the disc correctly.Two discs are inserted in a slot. Eject the disc magazine and insert the discs correctly.The disc is severely damaged. Use another disc.The power is not turned on. The wiring harness fuse blows. Check wires for shorts, then replace the fuse with one ofwith the same rating (shown on the case).The fader or balance is set to one side. Adjust the fader and balance.The volume level is minimum. Raise the volume level.Sound quality is poor.(Sound distortion)The volume level is too high. Use the appropriate volume level.EnglishThe O-N selection switch of the disc changer is not setproperly.Set the O-N selection switch to "O" position.

/ 21

Related manuals for Kenwood KDC-C467FM