Kenwood KDC-D300 Instruction Manual

Contents

Kenwood KDC-D300 Instruction Manual Manual pdf 6 page image

— 6 —EnglishOperationsINTEGRATED QUAD1 BIT D/ACONVERTERKDC-D300CD PLAYERDIGITAL OPTIMUMSERVO CONTROL11BAND11BANDSPECTRUM ANALYZER60 120 250 380 500 750 1k 2k 4k 8k 16kDPACDISPMENUButtons and DisplayThe various CD operations are performed with the Centre unit.For information about the operation method, please see theCentre unit instruction manual.• When inserting a CD, make sure the CD has been completelydrawn in before pushing back the faceplate. Failing to do somight scratch the CD.• Do not attempt to insert a CD into the slot if another one isalready there.• The unit can only play 12 cm (5 in). CDs. If you insert a 8 cm(3 in). CD, it will get stuck inside and can cause the unit tomalfunction.Operation for "N" Setting:A press of the release button causes the faceplate to12CAUTIONNOTEPlaying CDsSetting of the O-N switch will be required depending on theCentre unit that is to be connected. (See Page 10.)The operations you perform and the resultant operation of theunit will differ depending on the setting of the O-N switch.Please see the appropriate description of operations for the "O"or "N" switch setting.Release buttonDISP buttondrop to the front, thereby exposing the CD slot.Holding the CD with the labeled side facing up, insert it in theslot. The CD will start playing.Push back on the right side of the faceplate with your hand untilit locks.• Select "CD2" when this unit is connected to tha CD receiver.• Selection of the "CD" mode when a CD has not been loadedresults in the display of "EJECT" or "E-01".• For centre units brought on to the market from 1999onwards, it is not possible to switch to the CD mode unlessa CD has already been inserted.Operation for "O" Setting:A press of the release button causes the faceplate todrop to the front, thereby exposing the CD slot.Holding the CD with the labeled side facing up, insert it in theslot.Set the source mode of the centre unit to the "DISC" mode.CD play will begin.• Depending on the unit that is connected, "DISC-1" or "DISC-2"will be displayed.• Selection of the "DISC" mode when a CD has not beenloaded results in the display of "EJECT" or "E-01".• Setting the source mode of the Centre unit to a setting otherthan disc changer mode will cause the indicators and buttonillumination of this unit to be switched off, but the CDloading/eject operation will still be possible.• To allow the Centre unit to recognize this unit as a discchanger, disc switching operations such as the following arenot permitted: disc search and disc repeat, disc name presetplay, etc.NOTE321NOTE32