Kenwood KDC-DAB41U Instruction Manual

Also see for KDC-DAB41U: Instruction manual

30 EnglishInstallation/connectionPart list:A Faceplate ...................................................................(×1)B Escutcheon ..............................................................(×1)C Mounting sleeve...................................................(×1)D Wiring harness .......................................................(×1)E Removal tool .......................................................... (×2)F DAB antenna film *1 ............................................(×1)G DAB antenna amplifier *1 .................................(×1)H Cord clamper *1 .................................................... (×3)I Cleaner *1 ...................................................................(×1)• *1 KDC-DAB41U onlyBasic procedure1 Remove the key from the ignition switch,then disconnect the · terminal of thecar battery.2 Install the DAB antenna.\ (KDC-DAB41U only)> (page 34)3 Make proper input and output wireconnections.\ (page 32)4 Install the unit to your car.\ (page 33)5 Reconnect the · terminal of the carbattery.6 Reset the unit. (page 3)Warning■ The unit can only be installed in a car with a12 V DC power supply, negative ground.■ If you connect the ignition wire (red) andthe battery wire (yellow) to the car chassis(ground), you may cause a short circuit,that in turn may start a fire. Always connectthose wires to the power source runningthrough the fuse box.■ Disconnect the battery’s negative terminaland make all electrical connections beforeinstalling the unit.■ Insulate unconnected wires with vinyl tapeor other similar material. To prevent a shortcircuit, do not remove the caps on the endsof the unconnected wires or the terminals.■ Be sure to ground this unit to the car’schassis again after installation.■ If the power is not turned ON (“PROTECT”is displayed), the speaker wire may have ashort-circuit or touched the chassis of thevehicle and the protection function mayhave been activated. Therefore, the speakerwire should be checked.Caution■ If your car’s ignition does not have an ACCposition, connect the ignition wires to apower source that can be turned on andoff with the ignition key. If you connectthe ignition wire to a power source witha constant voltage supply, as with batterywires, the battery may die.■ Install this unit in the console of yourvehicle. Make sure the faceplate will not hitthe lid of the console (if any) when closingand opening.■ After the unit is installed, check whether thebrake lamps, blinkers, wipers, etc. on the carare working properly.■ Mount the unit so that the mounting angleis 30° or less.■ If the fuse blows, first make sure the wiresare not touching to cause a short circuit,then replace the old fuse with one that hasthe same rating.■ Connect the speaker wires correctly to theterminals to which they correspond. Theunit may be damaged or fail to work if youshare the · wires or ground them to anymetal part in the car.