Kenwood KDC-MP443U Instruction Manual

Also see for KDC-MP443U: Service manual

Contents

Kenwood KDC-MP443U Instruction Manual Manual pdf 12 page image

12 | KDC-MP5043U/ KDC-MP543U/ KDC-MP443UAudio ControlYou can adjust following Audio Control items;Adjustment Item Display RangeSubwoofer level “SW L” –15 — +15Bass Boost “B.BOOST”/ “B.B” “1”/”2”/“OFF” (Theindicator turns onaccording to the setting.)System Q “NATURAL”/ “ROCK”/“POPS”/ “EASY”/“TOP40”/ “JAZZ”/“GAME”/ “USER”Natural/Rock/Pops/Easy/Top 40/Jazz/Game/UsersettingBass level* “BAS L” –8 — +8Middle level* “MID L” –8 — +8Treble level* “TRE L” –8 — +8Balance “BAL” Left 15 — Right 15Fader “FAD” Rear 15 — Front 15Exit Audio Control mode (Volume control mode)* Source tone memory: Puts the set up value in thememory per source.⁄• “USER”: This appears when Bass level, Middle level, andTreble level are adjusted. When “USER” is selected, theselevels are recalled.1 Select the source to adjustPress the [SRC] button.2 Enter Audio Control modePress the [AUD] knob.3 Select the Audio item to adjustPress the [AUD] knob.4 Adjust the Audio itemTurn the [AUD] knob.5 Exit Audio Control modePress any button.Press a button other than the [AUD] knob.Audio AdjustmentsAudio SetupYou can set Sound system, such as follows;Adjustment Item Display RangeLow Pass Filter “LPF” 80/120/160/Through(OFF) HzVolume offset “V-OFF” –8 — ±0 (AUX: –8— +8)⁄• Volume offset: Sets each source’s volume as a differencefrom the basic volume.1 Select the source to adjustPress the [SRC] button.2 Enter Audio Setup modePress the [AUD] knob for at least 1 second.3 Select the Audio Setup item to adjustPress the [AUD] knob.4 Adjust the Audio setup itemTurn the [AUD] knob.5 Exit Audio Setup modePress the [AUD] knob for at least 1 second.Speaker SettingFine-tuning so that the System Q value is optimalwhen setting the speaker type as follows;Speaker type DisplayOFF “SP OFF”For 5 & 4 in. speaker “SP 5/4”For 6 & 6x9 in. speaker “SP 6*9/6”For the OEM speaker “SP OEM”1 Enter StandbyPress the [SRC] button.Select the “STANDBY” display.2 Enter Speaker Setting modePress the [AUD] knob.3 Select the Speaker typeTurn the [AUD] knob.4 Exit Speaker Setting modePress the [AUD] knob.