Kenwood KDC-MP535U Instruction Manual

Also see for KDC-MP535U: Firmware update guide Installation manual Service manual

Kenwood KDC-MP535U Instruction Manual Manual pdf 33 page image

English | 33Removing the hard rubber frame1 Engage the catch pins on the removal tool andremove the two locks on the upper level.Upper the frame and pull it forward as shown inthe figure.CatchLockAccessory2Removal tool2 When the upper level is removed, remove thelower two locations.⁄• The frame can be removed from the bottom side in thesame manner.Removing the Unit1 Refer to the section frame> and then remove the hard rubber frame.2 Remove the screw (M4 × 8) on the back panel.3 Insert the two removal tools deeply into the slotson each side, as shown.4 Lower the removal tool toward the bottom, andpull out the unit halfway while pressing towardsthe inside.Screw (M4X8)(commercially available)Accessory2¤• Be careful to avoid injury from the catch pins on theremoval tool.5 Pull the unit all the way out with your hands, beingcareful not to drop it.Screwing the Faceplate on the UnitIf you want to fasten the faceplate to the main unitso that it does not fall off.1 Refer to the section frame> and then remove the hard rubber frame.2 Drop open the faceplate by pressing the Releasebutton.3 Tighten the screw (ø2 × 5 mm) (Accessory 5) andbracket (Accessory6 ) in the hole shown on thediagram.Accessory5Accessory64 Tighten the screw (ø2 × 5 mm) (Accessory 5) andbracket (Accessory7) in the hole shown on thediagram.Accessory5Accessory7¤• Never insert the screws in any other screw hole than theone specified. If you screw them in another hole, it willcontact and may cause damage to the mechanical partsinside the unit.