Kenwood KDC-MP632U Instruction Manual

Also see for KDC-MP532U: Service manual Instruction manual Instruction manual

Contents

Kenwood KDC-MP632U Instruction Manual Manual pdf 39 page image

To USB deviceEnglish | 39Connecting Wires to Terminals (KDC-X590)ANT.CONTMUTEP.CONTILLUMIEXT.CONTFRONT LFRONT RREAR LREAR R–+SUBWOOFERREM.CONTBatteryGround wire (Black) - (To car chassis)FM/AM antenna inputFuse (10A)Wiring harness(Accessory1)Ignition wire (Red)Battery wire (Yellow)ACCCar fuse boxIf no connections are made, do not let the wire come out from the tab.When using the optional power amplifier,connect to its power control terminal. Power control wire (Blue/White)Motor antenna control wire (Blue)Depending on what antenna you are using,connect either to the control terminal of themotor antenna, or to the power terminal for thebooster amplifier of the film-type antenna.To front left speakerTo front right speakerTo rear left speakerTo rear right speakerWhite/BlackWhiteGray/BlackGrayGreen/BlackGreenPurple/BlackPurpleIgnition key switchCar fuse box(Main fuse)TEL mute wire (Brown)Connect to the terminal that is groundedwhen either the telephone rings or duringconversation.To connect these leads, refer tothe relevant instruction manuals.To connect the Kenwood navigationsystem, consult your navigation manual.To Kenwood disc changer/ External optional accessoryDimmer control wire (Orange / White)To car light control switchRear left output (White)Rear right output (Red)Front left output (White)Front right output (Red)Sub Woofer left output (White)USB connectorSub Woofer right output (Red)To use the steeringwheel remotecontrol feature,you need to anexclusive remoteadapter (notsupplied) matchesyour car is required.Steering remotecontrol (Light Blue/Yellow)• Do not remove the cap when you do not use theUSB cable. The connector will cause the unit tomalfunction if it gets in touch with any metallic partof the vehicle.• Fasten the connector with the tape so that the cablewill not come off.External amplifier control wire (Pink/Black)To "EXT.AMP.CONT." terminal of the amplifierhaving the external amp control function.