Kenwood KDC-MP8029 Instruction Manual

Also see for KDC-MP8029: Service manual Service manual

Kenwood KDC-MP8029 Instruction Manual Manual pdf 12 page image

12 | EnglishGeneral featuresSpeaker SettingFine-tuning so that the System Q value is optimalwhen setting the speaker type.1 Enter StandbyPress the [SRC] button.Select the "STANDBY" display.2 Enter Speaker Setting modePress the [VOL] knob."SP SEL" is displayed.3 Select the Speaker typeTurn the [VOL] knob.Each time the knob is turned, the settingswitches as shown below.Speaker type DisplayOFF "OFF"For 5 & 4 in. speaker "5/4 inch"For 6 & 6x9 in. speaker "6x9/6 inch"For the OEM speaker "O.E.M."4 Exit Speaker Setting modePress the [VOL] knob.Subwoofer OutputTurning the Subwoofer output ON or OFF.Hold down on [AM] of the Control knob for atleast 1 second.Each time the button is pressed, Subwooferoutput switches ON and OFF.When it’s ON, "SW ON" is displayed.• You can control this function when preout> (page 32) is set to "SWPRE Sub-W". (KDC-MP8029 only)• You can control this item when "2 ZONE" of Setup> (page 10) is set to "OFF".Display Mode SwitchingSwitching the display mode.1 Select the key function sectionPress the [NEXT] button.Repeatedly press the button until "DISP" isdisplayed above the [2] button.Refer to (page 8).2 Enter display control modePress the [2] ("DISP") button.3 Select the display modePress the [1] ("MODE") button.4 Select the display TypePush the Control knob to [4] or [¢].Each time the knob is pushed, the display modeswitches as shown below.Display Mode Display"Display Type A" 1"Display Type B" 1 2"Display Type C" 433 53 6"Display Type D" 4 768 8 8 8 8 8"Display Type E"* 91 Graphic display part2 Text display part3 Text icon display part4 Upper text display part5 Middle text display part6 Lower text display part7 Source icon display part8 Function item display9 G-Analyzer display part