18 | KDC-U7046BT/ KDC-U7046BTL/ KDC-U6046/ KDC-U6046LFunction setting47 Device Regist: “Device Regist.”Register a Bluetooth device (pairing). Refer to (page 26).48 Special Device Regist: “SPCL DVC Select”Allow registration of a special device that cannotbe registered normally. Refer to Special Bluetooth device> (page 26).49 Device Delete: “Device Delete”Cancel registration of the Bluetooth device. Referto (page 28).50 PIN Code Edit: “PIN Code Edit”Specify the PIN code required when registeringthis unit using the Bluetooth device. Refer to (page 27).51 Setting the Time Interval for AutomaticAnswer: “Auto Answer” ➤ ”OFF”, “0SEC” – “8SEC”– “99SEC”This function automatically answers (respondsto) a call after lapse of the preset time interval forautomatic answer.“OFF” : Does not answer the phone callautomatically.“0” : Automatically answers the phone call at once.“1s” – “99s” : Automatically answers the phone callafter lapse of 1 – 99 seconds.52 Speaker Select: “Bluetooth HF/Audio” ➤ “Front”,”All”You can specify output speakers for hands-freevoice communication and Bluetooth audio sound.“Front” : Outputs sound from the front speakers.“All” : Outputs sound from the front and rearspeakers.53 Setting the Beep of the Incoming Call: “CallBeep” ➤ “ON”, ”OFF”You can output a beep from the speaker when acall comes in.“ON” : Beep is heard.“OFF” : Beep is canceled.54 BT F/W Update: “BT F/W Update”Displays the firmware version and update thefirmware. Refer to Version> (page 29).55 MIC Gain: “MIC Gain” ➤ “-3” – ”0” – “+3”Adjusts the sensitivity of the built-in microphonefor a telephone call. Adjust the voice of caller.Setting to “+” increases the voice volume.Function of the KDC-U7046BT/ KDC-U7046BTL56 Noise Cancel: “NR Level” ➤ “-3” – ”0” – “+3”Reduces the noises generated by surroundingenvironment without changing the built-inmicrophone volume. Adjust the voice of callerwhen it is not clear. Setting to “+” increases thenoise reduction.Function of the KDC-U7046BT/ KDC-U7046BTL.57 Echo Cancel Level: “Echo Cancel” ➤ “-2” – ”0”– “+2”Sets the echo cancellation level.Function of the KDC-U7046BT/ KDC-U7046BTL.58 MIC Select: “MIC Select” ➤ “Builtin”, ”External”Determines whether the built-in or externalmicrophone is to be used when the receiverincorporates a microphone.Builtin: Use the built-in microphone.External: Use the external microphone.Function of the KDC-U7046BT/ KDC-U7046BTL.⁄• The Bluetooth Function setting items can be set while inthe Bluetooth mode without selecting the Function settingmode.1. Press the [ ] button ( KDC-U7046BT KDC-U7046BTL )/[FNC] button for at least 1 second ( KDC-U6046KDC-U6046L ) to enter the Bluetooth mode.2. Turn the Control knob to select “BT Setting”, and thenpress the [ENTER] button.3. Turn the Control knob to select desired item, and thenpress the [ENTER] button.4. Turn the Control knob to select value, and then press the[ENTER] button.
