Kenwood KDC-W4044UA Service Manual

Contents

12KDC-W4044UA/W4044UAY/W4044UG/W4044UGYKDC-W413UA/W413UAY/W4544U/W4644UYKey Description of display Description/CD timecode errorcount datadisplay(count notupdated)C N T S T A Y CD time code error count data (count not updated) mode display.C D D A : X X Number of CD-DA count errorsXX: Number of errors. “– –” is displayed in case there is no error.■ Test mode specifi cations in TUNER sourceError is found in front-end (A1), etc. if indications below is displayed while in tuner source.Status Display DescriptionFront-end (A1) E2PROM data error T N E 2 P N G Front-end (A1) E2PROM is still the default (unspecifi ed) value.Front-end (A1) communication error T N C O N N G Communication with front-end (A1) is not possible.Destination mismatch T N T Y P N G When destination is mismatch between front-end E2PROMand the product.• TUNER preset operationKey Description of display Description4 Preset function F M 1 9 8 . 3 A 4 Change to 98.3MHz with the preset key [4].• K3I forced switchingEvery time when [6] key is pressed in tuner FM source, switched in the following order: AUTO → Forced WIDE → Forced MIDDLE → ForcedNARROW → AUTO. Default status is AUTO, and displayed as shown below.Key Description of display Description6 K3I Forced switchingF M 1 9 8 . 1 A AUTOF M 1 9 8 . 1 W Forced WIDEF M 1 9 8 . 1 M Forced MIDDLEF M 1 9 8 . 1 N Forced NARROW• FST adjustment modePerform FST soft-mute adjustment.Key Note■DISP To enter into FST adjustment mode (Press and hold the key for 1 second)In FM, the frequency changes to 98.3MHzOperations in the FST adjustment mode are as follows:Key Description of display DescriptionFM(UP)AM(DOWN)/ Soft muteadjustment S M D - F 0 ↔ 7Seek Stop Leveladjustment(Auto)A T N V 0.00(V) ↔ 5.00 (V) Normal (Local OFF)Seek Stop Leveladjustment(Auto)A T L V 0.00(V) ↔ 5.00 (V) Normal (Local ON)TEST MODE