Kenwood KDC-W6527SE Instruction Manual

Also see for KDC-W6527: Service manual

Kenwood KDC-W6527SE Instruction Manual Manual pdf 10 page image

10 | EnglishGeneral featuresSystem QYou can recall the best sound setting preset fordifferent types of music.1 Select the source to setPress the [SRC] button.2 Select the Sound typePress the [Q] button.Each time the button is pressed the soundsetting switches.Sound setting DisplayNatural "Natural"User memory "USER"Rock "ROCK"Pops "POPS"Easy "EASY"Top 40 "TOP 40"Jazz "JAZZ"• User memory: The values set on the 'Audio Control'(page 10).• Each setting value is changed with the 'SpeakerSetting' (page 10).First, select the speaker type with the Speaker setting.Audio Control1 Select the source for adjustmentPress the [SRC] button.2 Enter Audio Control modePress the [AUD] button for at least 1 second."Audio Control" is displayed.3 Select the Audio item for adjustmentPress the [FM] or [AM] button.Each time the button is pressed the items thatcan be adjusted switch as shown below.4 Adjust the Audio itemPress the [4] or [¢] button.Adjustment Item Display RangeBass Center Frequency "Bass FRQ" 60/70/80/100 or 150 HzBass level "Bass" –8 — +8Bass Q Factor "Bass Q" 1.00/1.25/1.50/2.00Bass Extend "Bass EXT" ON/OFFMiddle Center Frequency "MID FRQ" 0.5/1.0/1.5/2.0 kHzMiddle level "MID" –8 — +8Middle Q Factor "Middle Q" 1.0/2.0Treble Center Frequency "TRE FRQ" 10.0/12.5/15.0/17.5 kHzTreble level "TRE" –8 — +8Balance "Balance" Left 15 — Right 15Fader "Fader" Rear 15 — Front 15Sub woofer level*¹ "SW Level" –15 — +15Front/Rear High Pass Filter "HPF" Through/100/125/170HzSub woofer Low PassFilter*¹"LPF SW" 50/80/120/Through HzVolume offset "VolumeOffset"–8 — ±0Loudness "Loudness" ON/OFF• According to the Bass Q Factor setting value, thefrequencies that can be set in Bass Center Frequencychange as shown below.Bass Q Factor Bass Center Frequency1.00/1.25/1.50 60/70/80/1002.00 60/70/80/150• When the Bass Extend is set to ON, low frequencyresponse is extended by 20%.• Volume offset: Each source’s volume can be set as adifference from the basic volume.• Loudness: Compensating for low and high tonesduring low volume.• *¹ You can control this item when 'Switching preout'(page 27) is set to "SWPRE Sub-W".5 Exit Audio Control modePress the [AUD] button.Speaker SettingFine-tuning so that the System Q value is optimalwhen setting the speaker type.1 Enter StandbyPress the [SRC] button.Select the "STANDBY" display.2 Enter Speaker Setting modePress the [Q] button."Speaker Setting" is displayed.3 Select the Speaker typePress the [4] or [¢] button.