Kenwood KDC-X597 Instruction Manual

Also see for KDC-BT355U: Instruction manual Instruction manual

Contents

BLUETOOTH®You can operate Bluetooth devices using this unit.MIC (Microphoneinput term:y:hone (supplied)Rear panel Secure using cord clamps (notsupplied) if necessary.Adjust themicrophone angleIf you turn off the unit or detach the control panel during a phonecall conversation, the Bluetooth connection is disconnected.Continue the conversation using your mobile phone.Supported Bluetooth profilesHands-Free Profile (HFP) I Serial Port Profile (SPP) I PhonebookAccess Profile (PBAP) I Object Push Profile (OPP) I Advanced AudioDistribution Profile (A2DP) I AudioNideo Remote Control Profile(AVRCP)When connecting a Bluetooth device to the unit for the first time,perform pairing between the unit and the device. Once the pairingis completed, the Bluetooth device will remain registered in the uniteven if you reset the unit.• Up to five devices can be registered (paired) in total.• A maximum of two Bluetooth phones and one Bluetooth audiodevice can be connected at any time.10• This unit supports Secure Simple Pairing (SSP).• Some Bluetooth devices may not automatically connect to the unit after pairing. Connect thedevice to the unit manually. Refer to the instruction manual of the Bluetooth device for moreinformation.1 Press C!> SRC to turn on the unit.2 Search and select this unit model name (KDC-XS**/ KDC-BTS**U/ KDC-BT3**U) on theBluetooth device."PAIRING"-+ "PASS XXXXXX" .. Device name-+ "PRESS"-+ "VOLUME KNOB" scrolls on thedisplay.3 Press the volume knob to start pairing."PAIRING OK" appears when pairing is completed and "BT" will light up when the Bluetoothconnection is established.• For some Bluetooth devices, you may need to enter the Personal Identification Number (PIN)code immediately after searching.• Pairing request (via Bluetooth) is automatically activated if an iPhone/iPod touch is connectedthrough the USB input terminal. (Applicable only if [AUTO PAIRING]/ [AUTO PAIR] is set to [ON].)(... 12)Press the volume knob to pair once you have confirm the passcode.You can check the connectivity of the supported profile between the Bluetooth device and theunit.1 Press~ to enter Bluetooth mode.2 Turn the volume knob to select [BT TEST MODE]/ [BT TEST], then press the knob."PLEASE PAIR YOUR PHONE" appears.3 Search and select this unit model name (KDC-XS**/ KDC-BTS**U/ KDC-BT3**U) on theBluetooth device.4 Press the volume knob to start pairing and begin the test mode."PAIRING" flashes on the display.The connectivity result (OK or NG) appears after the test.PAIRING: Pairing statusHF CNT: Hands-Free Profile (HFP) compatibilityAUD CNT: Advanced Audio Distribution Profile (A2DP) compatibilityPB DL: Phonebook Access profile (PBAP) compatibility• To cancel, press~.