8|EnglishGeneral featuresAdjusting the detail of Audio ControlAmong the Basic Audio items, you can adjust the Basslevel, Middle level, and Treble level in detail.1Select the Basic Audio itemSelect the desired item to be set in detail fromfollowings;• Bass level• Middle level• Treble levelFor how to select Basic Audio items, see Control> (page 7).2Enter Detail adjustment mode of AudioControlPress the [VOL] knob for at least 1 second.3Select the Detail Audio item to adjustPress the [VOL] knob.Each time you press the knob, the item to beadjusted alternates between the items shown inthe table below.4Adjust the Detail Audio itemTurn the [VOL] knob.Bass levelAdjustment ItemDisplayRangeBass Center Frequency"BASS FRQ"40/50/60/70/80/100/120/150 HzBass Q Factor"BASS Q FACTOR"1.00/1.25/1.50/2.00Bass Extend"BASS EXT"OFF/ONMiddle levelAdjustment ItemDisplayRangeMiddle Center Frequency "MIDDLE FRQ"0.5/1.0/1.5/2.0 kHzMiddle Q Factor"MIDDLE Q FACTOR" 1.00/2.00Treble levelAdjustment ItemDisplayRangeTreble Center Frequency"TREBLE FRQ"10.0/12.5/15.0/17.5 kHz5Exit the Detail Audio Control modePress the [VOL] knob for at least 1 second.⁄• When you set the Bass Extend to ON, low frequencyresponse is extended by 20%.• You can exit the Audio Control mode at anytime bypressing any button except for [VOL] konb and [ATT]button.Audio SetupSetting the Sound system, such as Cross overNetwork.1Select the source to adjustPress the [SRC] button.Refer to (page 6).2Enter Audio Setup modePress the [VOL] knob for at least 1 second.3Select the Audio Setup item to adjustPress the [VOL] knob.Each time you press the knob, the item to beadjusted alternates between the items shown inthe table below.4Setup the Audio itemTurn the [VOL] knob.Adjustment ItemDisplayRangeFront High Pass Filter"HPF-F Fc"Through/40/60/80/100/120/150/180/220 HzRear High Pass Filter"HPF-R Fc"Through/40/60/80/100/120/150/180/220 HzLow Pass Filter"LPF-SW Fc"50/60/80/100/120/Through HzSubwoofer Phase"SW PHASE"Reverse (180°)/ Normal (0°)Volume offset"VOL-OFFSET"–8 — ±0 (AUX: -8— +8)Loudness"LOUD"OFF/ONDual Zone System"2 ZONE"OFF/ON⁄• Volume offset: Sets each source’s volume as a differencefrom the basic volume.• Loudness: Compensates for low and high tonesduring low volume. (Only the low tone iscompensated for when the tuner is selectedas a source.)• Dual Zone SystemMain source and sub source (Auxiliary input) outputFront channel and Rear channel separately.- Set up the channel of sub source by System Setting> (page 27).- Select Main source by [SRC] button.- Adjust the volume of Front channel by [VOL] knob.- Adjust the volume of Rear channel by (page 7).- The Audio Control has no effect on sub source.• You can use the Dual Zone System with the internalauxiliary input.5Exit Audio Setup modePress the [VOL] knob for at least 1 second.
