English— 50 —CD/External disc control modeThe computer chip in the unit is not functioning normally. Press the reset button on the unit (see p. 4).The disc control mode cannotbe selected.No wire has been connected to the disc changer inputterminal on the unit.Connect the wire to the disc changer input terminal onthe unit.The specified disc does notplay, but another one playsinstead.The specified CD is quite dirty. Clean the CD.The CD is upside-down. Load the CD with the labeled side up.The disc is loaded in a different slot from that specified. Eject the disc magazine and check the number for thespecified disc.The disc is severely scratched. Try another disc instead.The sound skips. Something is touching the disc changer. Remove whatever is touching it.The CD is scratched or dirty. If skipping happens at the same place when the car isstopped, something with the CD is wrong. Clean the CD.The display shows that thechanger is being played, but nosound can be heard.The specified track will notplay.Random play or magazine random play has beenselected.Turn off random play or magazine random play.SOLUTIONPOSSIBLE CAUSEPROBLEMTrack repeat, disc repeat, trackscan, random play, andmagazine random play start bythemselves.The setting is not canceled. The settings for these functions remain on until thesetting to off or the disc ejected, even if the power isturned off or the source changed.Troubleshooting GuideIf the following situations, consult your nearest service center:• Even though the disc changer is connected, the Disc Changer Mode is not on, with "AUX" showing in the display during the Changer Mode.• Even though no device (KCA-S210A, CA-C1AX, KDC-CPS87, KDC-CX87, KDC-CPS85, KDC-CX-85, KDC-CPS82 or KDC-CX82) is connected, the AUX Mode isentered when switching modes.Cannot play CD-R or CD-RW. Finalization processing is not being conducted for CD-R/CD-RW.Conduct finalization processing with CD recorder.A non-compatible CD changer is being used to play theCD-R/CD-RW.Use a CD changer compatible with CD-R/CD-RW to play.