Kenwood KDC-X879 Instruction Manual

Also see for KDC-MP925: Service manual Instruction manual

Contents

English | 412 Select the item for adjustmentPress the desired [2] — [5] button.Each time the button is pressed the items thatcan be adjusted switch as shown below.Adjustment Item Button DisplaySearch down in category [2] "CS–"Search up in category [3] "CS+"Search down for channel in selected category [4] "CH–"Search up for channel in selected category [5] "CH+"• You cannot operate this unit until all the Categoryinformation is acquired.Function of remoteDirect Access TuningEntering the channel and tuning.1 Enter Direct Access Tuning modePress the [DIRECT] button on the remote.2 Enter the channelPress the number buttons.3 Do Channel SearchPress the [4] or [¢] button.Canceling Direct Access TuningPress the [DIRECT] button on the remote.• If you make no button operation for 10 seconds, theDirect Access Tuning mode is automatically canceled.• You can set up to Channel number 223.• If there is no signal in the input Channel, "NOCHANNEL" appears.• If you cannot receive any signal in the input Channeldue to a bad condition on radio wave or anotherproblem, "Acquiring Signal" appears.Selecting the Preset BandPress the [FM] button.Each time the button is pressed the preset bandswitches between the SR1, SR2, SR3 and SR4.Channel Preset MemoryPutting the channel in the memory.1 Select the preset bandPress the [FM] button.2 Select the channel to put in the memoryPress the [4] or [¢] button.3 Select the key function sectionPress the [NEXT] button.Repeatedly press the button until "[1]" — "[6]" aredisplayed above the [1] — [6] buttons.Refer to 'Notes on Multi-function Key System'(page 9).4 Put the channel in the memoryPress the desired [1] — [6] button for at least2 seconds.The preset number display blinks 1 time.On each band, 1 channel can be put in thememory on each [1] — [6] button.• Only the channel number is stored. Categoryinformation is not stored.Preset TuningCalling up the channels in the memory.1 Select the preset bandPress the [FM] button.2 Select the key function sectionPress the [NEXT] button.Repeatedly press the button until "[1]" — "[6]" aredisplayed above the [1] — [6] buttons.Refer to 'Notes on Multi-function Key System'(page 9).3 Call up the channelPress the desired [1] — [6] button.