Kenwood KIV-BT900 Instruction Manual

Also see for KIV-700: Quick start guide Quick start guide Quick start guide Instruction manual Service manual

Contents

Kenwood KIV-BT900 Instruction Manual Manual pdf 46 page image

46 | KIV-BT900/ KIV-700DSP SetupAudio Preset MemoryRegistering the value setup by Sound Control.1 Setup Sound ControlRefer to the following operations to setup theSound Control.- Car Type Selection (page 44)- Speaker Setting (page 44)- Car Type Fine Adjustments (page 45)- X’Over Setting (page 46)- Manual Equalizer Control (page 41)- Listening Position Selection (page 42)- Listening Position Fine Adjustments (page 42)2 Enter Audio preset memory modeTurn the [Volume] knob and press it when thedesired item is displayed.Select “Detailed Setup” > “Preset” > “PresetMemory”.3 Select the number to put in the memoryTurn the [Volume] knob and press it when thedesired item is displayed.Select a preset number.4 Turn the [Volume] knob and press it when thedesired item is displayed.Select “YES”.“Completed” is displayed.5 Exit Audio Control modePress the [MENU] button for at least 1 second.⁄• Register 6 patterns of Audio Preset Memory.• Preset number “1”:When you press the Reset, all the sources will be thesetting value which is registered.• Preset number “1” and “2”:The memory cannot be erased by the Reset button.• This function cannot be registered when the iPodEqualizer set in (page 41).X’Over SettingFine adjusting the following setting valuescorresponding to the X’Over values set in thesection (page 44).Display Item Range“X’Over”“Front” “FC” Front High Pass FilterThrough, 30, 40, 50, 60, 70, 80, 90,100, 120, 150, 180, 220, 250 (Hz)“SLOPE” Front High Pass Slope-6, -12, -18, -24 dB/Oct“Rear” “FC” Rear High Pass FilterThrough, 30, 40, 50, 60, 70, 80, 90,100, 120, 150, 180, 220, 250 (Hz)“SLOPE” Rear High Pass Slope-6, -12, -18, -24 dB/Oct“Subwoofer” “FC” Subwoofer Low Pass Filter30, 40, 50, 60, 70, 80, 90, 100, 120,150, 180, 220, 250, Through (Hz)“SLOPE” Subwoofer Slope-6, -12, -18, -24 dB/Oct“PHASE” Subwoofer PhaseReverse (180°)/ Normal (0°)1 Enter Audio Control modePress the [Volume] knob.2 Enter X’Over setting modeTurn the [Volume] knob and press it when thedesired item is displayed.Select “Detailed Setup” > “X’Over”.3 Select the speaker you want to setTurn the [Volume] knob and press it when thedesired item is displayed.Select “Front”, “Rear”, or “Subwoofer”.4 Select the setting item to adjustTurn the [Volume] knob and press it when thedesired item is displayed.5 Make a settingTurn the [Volume] knob to select a settingvalue, and then press the [Volume] knob.6 Repeat steps 3 to 5 to complete the X’Oversettings7 Exit Audio Control modePress the [MENU] button for at least 1 second.