English | 251 Enter StandbyPress the [SRC] button.Select the "STANDBY" display.2 Enter Menu modePress the [MENU] button for at least 1 second.When "Menu" is displayed, "Security" is displayed.3 Enter Security Code modePress the [4] or [¢] button for at least 1second.When "Enter" is displayed, "CODE" is displayed.4 Select the digits to enterPress the [4] or [¢] button.5 Select the Security Code numbersPress the [FM] or [AM] button.6 Repeat steps 4 and 5, and complete theSecurity Code.7 Confirm the Security CodePress the [4] or [¢] button for at least 3seconds.When "Re-Enter" is displayed, "CODE" is displayed.8 Do the step 4 through 7 step operation, andreenter the security code."Approved" is displayed.The Security Code function activates.• If you enter a Code different from your Security Code,you have to start over from step 4.Press the Reset button and when it’s removedfrom the battery power source1 Turn the power ON.2 Do the step 4 through 7 step operation, andreenter the security code."Approved" is displayed.The unit can be used.• If an incorrect code is input, "Waiting" is displayed, andthe input prohibited time shown below is generated.After the input prohibited time lapses, "CODE" isdisplayed, and input can be done.Touch Sensor ToneSetting the operation check sound (beep sound)ON/OFF.Display Setting"Beep ON" Beep is heard."Beep OFF" Beep canceled.Manual Clock Adjustment• This adjustment can be done when the 'SynchronizeClock' (page 26) is set as OFF.1 Select Clock Adjustment modePress the [FM] or [AM] button.Select the "Clock ADJ" display.2 Enter Clock Adjust modePress the [4] or [¢] button for at least 1second.The clock display blinks.3 Adjust the hoursPress the [FM] or [AM] button.Adjust the minutesPress the [4] or [¢] button.4 Exit Clock adjustment modePress the [MENU] button.Number of times theincorrect code was inputInput prohibited time1 —2 5 minutes3 1 hour4 24 hours