Kenwood KMF-X9000 Instruction Manual

Also see for KMF-X9000: Service manual Service manual

Contents

Kenwood KMF-X9000 Instruction Manual Manual pdf 5 page image

5 EN7Mono (bridged, or BTL) configurationIn this configuration, the KMF-X9000’s two individual channels operate together to drive a single speaker (such as a subwoofer) inmono. This allows the amplifier to deliver more than double the power of one of its channels to the speaker.1 Make sure that the KMF-X9000’s power cord is unplugged from the wall outlet before making any connections.2 According to the speakers to be used, set the speaker impedance selector switch as follows:• For 6-16 Ω speakers: Set the 2Ω (STEREO)/6Ω OVER switch to 6Ω OVER and 6Ω OVER/2Ω switch to 2Ω.3 Connect the amplifier as shown in the diagram.• Make sure to connect the audio input cable to the MONO/BTL input.Except for EuropeNote: Since bridged operation produces enough output power to pose a small risk of electrical shock from the speaker termi-nals, please attach the terminal cover as shown in the diagram below:CLIPINDICATORCD 2 / TAPE 2MONITORSURROUNDBACK 96kfsDISCRETE 6.1 MATRIX 6.1 NEO : 6 PRO LOGICDTS-ESNow you can plug the power cord of this unit into the AC outlet!CAUTION:Before reconnecting a speaker cord or switching a selector switch, turn OFF the power and unplug the powercord to avoid malfunctions or damage to the unit.Except for EuropeMount the suppliedspeaker terminal coverusing the two screws thatare attached to the unit.KRF-X9995DWhen a monauralpre-out signal is tobe connected, besure to connect it tothe MONO/BTLterminal.Audio cord (not supplied) Stereo mini-plug cord (supplied)To wall ACoutletSubwoofers(6Ω-16Ω)For 12 V RELAY CONTROL, see page 6.

/ 8

Related manuals for Kenwood KMF-X9000