Kenwood KOS-V1000 Instruction Manual

Also see for KOS-V1000: Training guide Instruction manual Service manual

Contents

78 KOS-V1000Help? TroubleshootingSome functions of this unit may be disabled bysome settings made on this unit.! • Cannot set up the subwoofer.• Cannot set up subwoofer phase.• No output from the subwoofer.• Cannot set up the low pass filter.• Cannot set up the high pass filter.▲ Subwoofer is not set to On. ☞

(page 58)▲ The Dual zone function is enabled. ☞ Control> (page 76)! Cannot set up the subwoofer phase.▲ Subwoofer is not set to On. ☞

(page 58)▲ Low pass filter is set to Through. ☞ Network Setup> (page 59)! • Cannot select the output destination of thesubsource in the Dual zone.• Cannot adjust the volume of the rearspeakers.▲ The Dual zone function is disabled. ☞ Control> (page 76)! Cannot Folder select.▲ The Scan play or Random play function isenabled.! • The Traffic Information setting is ineffective.• The Synchronize Clock setting is ineffective.• Cannot select the tuner as a Dual zonesource.▲ HD Radio is in use.▲ Tuner souce function is disabled. ☞ Setup> (page 60)! • Cannot set up the equalizer.• Cannot set up the crossover network.▲ The Dual zone function is enabled. ☞ Control> (page 76)What might seem to be a malfunction in your unitmay just be the result of slight misoperation ormiswiring. Before calling service, first check thefollowing table for possible problems.General? The Touch Sensor Tone doesn’t sound.✔ The preout jack is being used.☞ The Touch Sensor Tone can’t be output fromthe preout jack.Tuner source? Radio reception is poor.✔ The car antenna is not extended.☞ Pull the antenna out all the way.✔ The antenna control wire is not connected.☞ Connect the wire correctly, referring to thesection on (page 84).Audio file source? The sound skips when an Audio file is beingplayed.✔ The recording condition is bad.☞ Record the media again or use anothermedia.