Kenwood KR-V999D Instruction Manual

Contents

1 1PreparationsOperationsOtherKR-V999D (En/T)VIDEO3VIDEO4VIDEO2(OPTICAL)AC-3DIGITAL INAC-3 DIGITALOUTPUT AC-3 RFOFF ONEXTERNAL DC SUPPLY DC 12VINPUT DC IN12V@ #AC-3 DIGITALOUTPUT AC-3 RFOFF ONINPUT DC IN12V@ #POWER LOCKLASER DISC RF DEMODULATOR DEM-999D21POWER LOCKLASER DISC RF DEMODULATOR DEM-999D53 4 6Make connections as shown below.The digital in jacks can accept either Dolby Digital (AC-3) or PCM signals (the input signal type is detected automatically).When connecting the related system components, be sure to also refer to the instruction manuals supplied with thecomponents you are connecting.Do not connect the power cord to a wall outlet until all connections are completed.Digital connectionsSetting up the systemComponent with an AC-3 (orPCM) COAXIAL DIGITAL OUTCOAXIAL DIGITAL OUT(AUDIO)Component with an AC-3 (orPCM) OPTICAL DIGITAL OUTOPTICAL DIGITAL OUT(AUDIO)1 POWER indicatorLights (red) when the power switch (5) is set to ON .2 LOCK indicatorLights when an AC-3 RF signal is input to the AC-3 RF INPUT jack (4).3 AC-3 DIGITAL OUTPUT (coaxial)Connect this jack to the coaxial AC-3 DIGITAL IN jack on your receiver.It outputs AC-3 coaxial digital signals when the POWER (5) is set toON and an AC-3 RF signal is input to the AC-3 RF INPUT jack (4).4 AC-3 RF INPUTConnect this jack to the AC-3 RF OUTPUT jack on your LD player.5 POWER switchUse to switch the power ON/OFF.6 DC IN (12V) jackConnect this jack and inlet power cord to the AC adaptor supplied withyour demodulator. Connect the power cord to a wall outlet aftercompleting all of the other connections.RCA pin cordAC-3 RF OUT(AUDIO)To connect an LD player with a DIGITAL RF OUT.Connect the LD player to the KENWOOD RF digitaldemodulator (DEM-999D). Then connect the demodu-lator to the VIDEO 4 DIGITAL IN.Connect the video signal and analog audio signals to theVIDEO 4 jacks. (See "Connecting video components".)Connect the video signal and analogaudio signals to the VIDEO 2 jacks.(See "Connecting video components".)Connect the video signal and analogaudio signals to the VIDEO 3 jacks.(See "Connecting video components".)Connect components capable of output-ting Dolby Digital (AC-3) or standard PCMformat digital signals.Place the power supply away from the demodulator,receiver, and any antennas.RCA pin cordOptical fiber cableAC-3 RF Demodulator DEM-999DRCA pin cord