Kenwood KRC-108S Instruction Manual

Contents

— 3 —take theuntil it is fullymay fall out of, battery, oruse automotive-ith a 0.75mm2wirethe wire coating.ver put or leavecoins or metalke or strangemediately andr.it or subject it tobecause ital fluid if the LCDshock. Thengerous to yourthe LCDg, wash it offTo prevent damage to the machine,take the following precautions:• Make sure to ground the unit to a negative12V DC power supply.• Do not open the top or bottom covers of theunit.• Do not install the unit in a spot exposed todirect sunlight or excessive heat or humidity.Also avoid places with too much dust or thepossibility of water splashing.• Do not subject the faceplate to excessiveshock, as it is a piece of precision equipment.• When replacing a fuse, only use a new onewith the prescribed rating. Using a fuse withthe wrong rating may cause your unit tomalfunction.• To prevent a short circuit when replacing afuse, first disconnect the wiring harness.• Do not use your own screws. Use only thescrews provided. If you use the wrongscrews, you could damage the unit.2CAUTIONPM Page 3