Kenwood KRC-369 Instruction Manual

Contents

English— 22 —The following messages are displayed when yoursystem condition.E-01: No disc magazine has been loaded in the changer.The disc magazine is not completely loaded.➪ Load the disc magazine properly.E01No CD in the unit.➪ Insert the CD.E-02: No disc has been loaded in the disc magazine.E02➪ Load a disc into the disc magazine.E-04: No disc has been loaded in the disc magazine.E04➪ Load a disc into the disc magazine.The CD is quite dirty. The CD is upside-down. The CDis scratched a lot.➪ Clean the CD and load it correctly.E-10: Nothing has been recorded on the MD.E10E-11: No tracks are recorded on the MD, although it has atitle.E11E-30: The faceplate of the slave unit being connected tothis unit has been removed.➪ Replace it.E30E-77: The unit is malfunctioning for some reason.E77➪ Press the reset button on the unit. If the "E- 77"code does not disappear, consult your nearestservice center.E-99: Something is wrong with the disc magazine. Or theunit is malfunctioning for some reason.E99➪ Check the disc magazine. And then press the resetbutton on the unit. If the "E-99" code does notdisappear, consult your nearest service center.E-0d: The protective circuit in the unit activates when thetemperature inside the automatic disc changerexceeds 60°C (140°F), stopping all operation.E0d➪ Cool down the unit by opening the windows orturning on the air conditioner. As the temperaturefalls below 60°C (140°F), the disc will start playingagain.LOAd: Discs are being exchanged in the Disc changer.E5723 (Blink): The tape player section is not operating properly.E60➪ Reinsert the Tape. If the tape cannot be ejected orthe display continues to flash even when the tapehas been properly reinserted, please switch off thepower and consult your nearest service center.Troubleshooting Guide

/ 24

Related manuals for Kenwood KRC-369