Kenwood KRC-478R<u>/RV</u> Instruction Manual

English— 26 —The use of any accessories except for those provided mightresult in damage to the unit. Make sure only to use theaccessories shipped with the unit, as shown above.2CAUTIONAccessories..........................................1..........................................2..........................................1123External view Number of itemsInstallation Procedure1. To prevent short circuits, remove the key from the ignition anddisconnect the -terminal of the battery.2. Make the proper input and output cable connections for each unit.3. Connect the cable on the wiring harness.4. Take Connector B on the wiring harness and connect it to thespeaker connector in your vehicle.5. Take Connector A on the wiring harness and connect it to theexternal power connector on your vehicle.6. Connect the wiring harness connector to the unit.7. Install the unit in your car.8. Reconnect the - terminal of the battery.9. Press the reset button.• If your car is not prepared for this special connection-system,consult your Kenwood dealer.• Only use antenna conversion adapters (ISO-JASO) when theantenna cord has an ISO plug.• Make sure that all cable connections are securely made byinserting jacks until they lock completely.• If your vehicle's ignition does not have an ACC position, or ifthe ignition cable is connected to a power source with constantvoltage such as a battery cable, the power will not be linkedwith the ignition (i.e., it will not turn on and off along with theignition). If you want to link the unit's power with the ignition,connect the ignition cable to a power source that can be turnedon and off with the ignition key.• If the fuse blows, first make sure that the cables have notcaused a short circuit, then replace the old fuse with one withthe same rating.• Do not let unconnected cables or terminals touch metal on thecar or anything else conducting electricity. To prevent shortcircuits, also do not remove the caps on the ends of theunconnected cables or the terminals.• Connect the speaker cables correctly to the terminals to whichthey correspond. The unit may receive damage or fail to work ifyou share the - cables and/or ground them to any metal part inthe car.• After the unit is installed, check whether the brake lamps,indicators, wipers, etc. on the car are working properly.• Insulate unconnected cables with vinyl tape or other similarmaterial.• Some disc changers need conversion cables for connection.See the section on "Safety Precautions" for details.• If the console has a lid, make sure to install the unit so that thefaceplate does not hit the lid when closing and opening.2CAUTION1:KRC-478R/378R/33R only