Kenwood KRC-535 Instruction Manual

Also see for KRC-535: Instruction manual Service manual

English— 26 —Make sure that the unit is installed securely in place. If the unit isunstable, it may malfunction (for example, the sound may skip).Bend the tabs of themounting sleeve witha screwdriver or similarutensil and attach it inplace.Metal mounting strap(commerciallyavailable)Phillips truss headsheet metal screw(commercially available)Firewall or metal supportScrew (M4X8)(commerciallyavailable)To attach this unit, make sure the front of the control panel faces youand fit it into the mounting sleeve by pressing the four corners of thehard rubber frame at the same time.Do not apply strong pressure to other sections than the corners;otherwise troubles such as the impossibility of opening or closing thepanel may result.Installation (non-Japanese cars)RL8mm5mm5mm8mmFor Nissan CarAfter aligning the J-Carbracket with the factory-installed radio bracket,tighten the screws.Accessory4for Toyota car Accessory3for Nissan carFactory trim bezelAccessory6J-Car Bracket(follow indications for L/R)Accessory7J-Car Trim Plate(place thick part on bottom)Factory-installedRadio BracketFactory-installedRadio BracketFor Toyota CarAfter aligning the factory-installed radio bracket,tighten the screws.Damage to the unit will result from using screws other than thoseprovided.A pair of J-Car Brackets (Accessory 6) are not used when fittingin a Toyota car.Installation (Japanese-cars)