Kenwood KRC-PS959R Instruction Manual

Also see for KRC-759R: Service manual Service manual Instruction manual

Contents

Kenwood KRC-PS959R Instruction Manual Manual pdf 26 page image

— 26 —EnglishDisc control features (See page 7)Presetting Disc NamesStore the names of discs to be displayed when played.Play the disc whose name you want to preset.• This function is not available for disc changers that do notfeature the Disc Name Preset function.• This procedure is not to be used to store the disc and tracktitles for MDs that you record.Press the NAME.S button for at least two seconds."NAME SET" is displayed and the disc name preset mode isentered.The cursor blinks in the position where character input can bemade.Press either the 4 or ¢ button to move the cursor to thedesired position.The 4 button moves the cursor to the left, and the ¢button to the right.You can also move the cursor left or right by pressing theTRACK + or TRACK – buttons, respectively, on the remotecontrol.Each time the 38 button is pressed, the characters to beentered change as listed below.Press the DISC + or DISC – button to display the desiredcharacter.Characters that can be displayed are as follows.tAlphabet (upper case): A ~ ZtAlphabet (lower case): a ~ z (KRC-PS959R Only)tNumerals and symbols: 1~9 0 @ ” ‘ ` % & ∗ + - = , . / \ < > [ ]tSpecial characters: á à é è í ì ó ò ú ù Ñ Ç ® ß ‹ fl â ä ê ëî ï ô ö û ü ñ ç © Æ › fi(KRC-PS959R Only)The operation and characters that can be entered may changeNOTE432NOTE1as listed below, depending on the unit that is connected.A press of the 38 button exits the disc name preset mode.Operations can be followed again from Step 2 at a time suchas this, and the characters to be input are selected using theprocedure described below.Press the DISC + or DISC – button to display the desiredcharacter. Besides the alphabet (capital letters only) andnumbers, you can choose the following characters: /, + , – , ∗,=, <, >, [ and ].Direct Alphabet InputIf the disc changers that were manufactured and sold after 1997are connected, you can directly input letters using thenumber/letter entry buttons on the remote control.Example: Use the following table to enter the name "DANCE".Continue steps 3 and 4 until all the characters are chosen forthe name.Press either the NAME.S button on the main unit or the OKbutton on the remote.The disc name is stored and the disc name preset mode iscanceled.If you make no entry in a 10-second period, the name will bestored with the characters input so far.• The number of characters and discs whose names can bestored will differ depending on the disc changer that isconnected. Please see your disc changer manual for details.• Discs are identified by their total length and number of tracks. Ifanother disc happens to have the same specifications as onethat you have already stored a name for, the name will bedisplayed for it, too.• If you want to change the name of a disc, repeat steps 1 and 2NOTE65NOTE#3 1“D”1“A” #2#6“N” 2#2 3“C”#3“E” 2Button to press # Times pressedCharacter