Kenwood KRF-V5020 Instruction Manual

Also see for KRF-V5020: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Kenwood KRF-V5020 Instruction Manual Manual pdf 8 page image

8PreparationsKRF-V7020/V6020/V5020 (En/T)REC OUTPHONO CD MD / TAPE VIDEO 2 / MONITORPLAY IN REC OUT PLAY INLR1 ¡47 6¢Make connections as shown below.When connecting the related system components, be sureto also refer to the instruction manuals supplied with thecomponents you are connecting.Do not connect the power cord to a wall outlet until allconnections are completed.Microcomputer malfunctionIf operation is not possible or an erroneous display appears, eventhough all connections have been made properly, reset the micro-computer referring to “In case of difficulty”. ∞Notes1. Be sure to insert all connection cords securely. If their connections areimperfect, the sound may not be produced or noise may interfere.2. Be sure to remove the power cord from the AC outlet before plugging orunplugging any connection cords. Plugging / unplugging connectioncords without disconnecting the power cord can cause malfunctions andmay damage the unit.3. Do not connect power cords from components whose power consump-tion is larger than what is indicated on the AC outlet at the rear of this unit.Connecting audio componentsCaution regarding placementTo AC wall outletCassette deck orMD recorderCD playerIN OUTRecord playerSYSTEM CONTROLjacks 0Shape of AC outletsFor U.K.For other countriesCassette deck orgraphic equalizer ^Setting up the systemTo maintain proper ventilation, be sure to leave a space around theunit (from the largest outer dimensions, including projections) equalto, or greater than shown below:Left and right panels: 10 cm, Rear panel: 10 cm, Top panel: 50 cmINOUTOUTOUTVIDEO 2/MONITOR jacksThe receiver’s VIDEO 2/MONITOR jacks can be used in two differentways. Make the appropriate setting for the component connected tothe jack when the receiver is turned on.Use as a VIDEO 2 jackYou can connect a video deck or the like to these jacks and performvideo playback and recording. The initial factory setting is “VIDEO2”.Use as a MONITOR jackYou can connect a cassette deck or the like to these jacks and makeuse of the deck’s monitoring function during recording. Alternately,you can connect a graphic equalizer to these jacks to apply compen-sation to the music signal.To use the VIDEO 2/MONITOR jacks as MONITOR jacks, hold downthe VIDEO 2/MONITOR key of the main unit for more two seconds sothat the indication shown below appears.• At the same time the setting is switched to “MONITOR,” the audio inputsource switches to tuner and the video input source switches to VIDEO1.• To switch the setting back to “VIDEO 2,” once again hold down theVIDEO 2/MONITOR key for two seconds or more.• If you decide to use the VIDEO 2/MONITOR jacks as MONITOR jacks,make sure to delete the “VIDEO 2 (VCR2)” input from the presetremote control (RC-R0508). RC6VIDEO 2/MONITORMONIT RO FMAMkHzMHz STEREODSPS.DIRECTASPMUTEMUTEDOWNMIXPRO LOGICTUNEDMEMO.AUTOST.AUTO SOUNDSWRL DIGITALBMONITORTo use these jacks as MONITORjacks, you must change theappropriate setting.To use the receiver for video recording, connect a video deck tothe VIDEO 2/MONITOR jacks.