Kenwood KRF-V7771D Instruction Manual

Also see for KRF-V7771D: Instruction manual Setup Instruction manual Service manual Service manual

Contents

21KRF-V7771D (En/T)SetupCode selection after mode downloadAfter successful completion of the download, step 5 of the previous page, the remote control automatically enters a specialset-up mode which works as described below.123 Set up all the downloaded codes.Select the input and component names that you want to register a setup code.Find out the numeric icon that outputs the power code of the component.Though the “Futureset” memory in your remote control is quite large, only 20 different devices power codes can be put on the keypad at anyone time. If you require a larger download, the standard setup procedure can be used. See “Assigning the connected components to theselected inputs”, your customer service representative can supply you with the downloaded setup codes numbers.Repeat the operations of step 1 and 2.1 Select the input name by selecting the or icon of“Selector” (input selector).This changes the section of “Video1” in the figure.2 Select the component name by selecting the or iconof “Device” (component connected to the rear panel inputjacks).This changes the section of “VCR” in the figure.3 Select the “Next” icon.The “Register Info.2” menu screen appears.1 Select the 1 icon to output its power code.÷ After selecting a numeric icon, be sure to press the ENTER key tooutput its power code.2 Select numeric icons in order from“ 1 ”until the compo-nent selected in step 1 is turned ON (i.e. repeat step 1 foreach numeric icon).3 Select the “Entr” icon after the component has turned ON.÷ The setup code for the last power code to be sent in step 2 isautomatically registered at the location selected in step 1.To delete a setup code1 Open the “Setup IR” menu screen shown on the left.÷ Follow the step 1 of “Assigning the connected components tothe selected inputs”. (2 Select the component to be deleted.Select the component with the “ ”or “ ” icon.3 Select the 4 digit code “9999”.4 Select the “Entr” icon.÷ Once the setup code is registered and you switch to a differentmenu screen, the code display is back to “#0000”.÷ When a setup code has been downloaded, the section where“#0000” displays “# - - - -”.When setup codes of more than one components have beendownloaded, note that all of the codes are interrelated betweeneach other. Therefore, if any of them is deleted, you shouldperform the procedure of “Setup of components which are notlisted in the Setup Codes chart” from the beginning.Setup for controlling AV componentsSetup IRMD/Tape1 MD#0000EntrClrCheck1 2 34 5 67 8 90Register Info.1NextVideo1SelectorVCRDevice123Register Info.2Entr 1 5 92 6 103 7 114 8 1213 1714 1815 1916 20213