Kenwood KRF-V7771D Instruction Manual

Also see for KRF-V7771D: Instruction manual Setup Instruction manual Service manual Service manual

Contents

39KRF-V7771D (En/T)OperationsPreset the selected stations.2Select the “Tuner” input and select a station.Manual memory of broadcast stations1 Select the “Tuner” icon.÷ The last tuned frequency is displayed.2 Select the receiving band.Select the “Band” icon.3 Select a station or frequency.Select the “ ”or “ ” icon.4 Select the “Memory/10key Pad” icon.1 Select “Memory” icon.÷ The memory mode ( Memory ) and preset call mode ( Memory ) areswitched alternately every time the icon is selected.2 Select one of the preset numbers from 1 to 40.Select numeric icons as follows...To preset in “15” ......... 05RDS (Radio Data System)Apart from the auto memory function, RDS stations can also be stored manually in the preset memory. Other stations than the RDSstations can also be stored in memory after the Auto Memory of RDS stations.1Receiving a manually preset station÷ If you made a mistake in entering the figure of 10, select the 0icon repeatedly until the original display is shown, then enter thecorrect number.1. Preset -Call2. Specifying the preset numberTunerRDS DirectMemory/10key PadFM 108.00MHzFreq.11chP.CallAuto Band÷ Every time the icon is selected, the next station in the order of thepreset number is received.If the icon is held selected ... Preset stations will be received suc-cessively for about half a second each.1 Select the “Memory” icon and switch to preset call mode( Memory ).2 Select the preset number (up to 40) of the desired presetstation.Select numeric icons as follows...To receive in “20” ....... 00)When “ P.Call ” icons are selectedSelect the “ ”or “ ” icon of ”P.Call” to select a preset number.When “ P.Call ” icons are selected0201 ......03 39 40380201 03 39 4038......÷ Repeat steps 1 and 2 for each of the stations to be stored inmemory.÷ In the manual memory storage operation of radio stations, it may takea few seconds after the “Memory” icon is selected till the memorydisplay starts to blink depending on the receiving condition.÷ If a station is stored in a preset number which has already storeda station memory under it, the previous memory is replaced by thenew memory content.÷ If RDS stations are stored manually in the preset memory, the PSmay not be included in the memory depending on receivingconditions.1-chMemory/10key PadAuto MemoryMemory 1 2 34 5 67 8 90 +10 21TunerRDS DirectMemory/10key PadFM 108.00MHzFreq.11chP.CallAuto BandTunerCD1Video2 Video3 Video4Video1TV1PhonoTV2CD2MD/Tape1CD2/Tape2InputDigitalInputAnalogAV AUX Macro RemoteModeMainMenu1234Memory/10key PadAuto MemoryMemory 1 2 34 5 67 8 90 +1011ch21