Kenwood KRF-X7775D Connection And Setup Manual

Also see for KRF-X7775D: User guide User guide Service manual

Contents

34Chapter Two : Setting Up Remote Control UnitSetting UpChapter Two: Setting Up Remote Control UniteThis Remote Control unit can be set up to remote controlthe receiver as well as most of the devices connected to it.The appearance and functions of the Remote Control unitare slightly different from other remote control units. Sinceit is used to remote control a large number of devices, itsscreen shows the information of each device in separatemenus.This Remote Control unit can remote control the deviceswhich are connected to the receiver and identified by theRemote Control unit.In case the Remote Control unit cannot remote control adevice you want to use, check if the device has been regis-tered for identification by the Remote Control unit. Themethod of registering devices in Remote Control unit willbe described later in this chapter.Before you can set up any Remote Control unit item, youneed to install batteries.• The batteries that came with your new Remote Controlunit are intended for you to use for an operation check—they may not last as long as ordinary batteries. We rec-ommend replacing them with batteries for normal use.To install the batteries:1. Slide down the battery cover as shown by the figure toremove it.2. Insert four AA(R6) batteries with the correct polarity.Then close the battery cover.Installing the BatteriesThis chapter is composed of the following sections.Installing the Batteries Page 34Resetting the Remote Control Unit Page 34Basic Operation of Remote Control Unit Page 35Setting Up Speakers Page 36Identifying Componentsfor Remote Control Unit Page 39If Remote Control unit is used outside the remote controlrange, the screen may show erroneous information. For theremote control range, refer to page 7 (“Remote controllablerange”) in the Users’ Guide.When the remote control range reduces or the Low Batteryindicator ( ) will flash in the LCD screen, replace all ofthe four batteries together.To extend the battery life, we suggest that you keep the back-light off except when necessary. For the backlight, refer tothe Users’ Guide.Resetting the Remote Control UnitThe Remote Control unit can be reset in two waysTo reset the remote without clearing the setups:• Remove the batteries then reload them again.This resets the Remote Control unit but the speakersetup and device setup remain unchanged.To reset everything and initialize the remote to thefactory condition:1. Remove the batteries.2. While holding the (function up) button andbutton simultaneously, load the batteries.3. Release the above buttons.This operation resets all of the setups made by the user.2WAY LCD REMOTE CONTROL UNIT+-+-1 2 34 5 67 8 910 11 12+10 0 +100/8/711