Kenwood KSC-SW10 Instruction Manual

Also see for KSC-SW10: Training guide Product information Instruction manual

Contents

ENGLISH EnglishConnecting the subwoofer to the subwoofer (non-fader) output of the center unitConnect the subwoofer to the subwoofer output(non-fader output) or the RCA jacks for the frontoutput of the center unit.Notes:• Read the instruction manuals for the connected componentssuch as the center unit as well as this instruction manual.• Please purchase an RCA cord that is commercially availableseparately.Use the provided RCA cord 9 for connection between the sub-woofer and the separately purchased RCA cord.• When the center unit incorporates a DSP, connect the subwoof-er to the subwoofer output (non-fader output) or to the RCAjacks for the front output. Do not connect to the RCA jacks forthe rear output, as the low-frequency reproduction effect maybe attenuated due to the DSP effect.Front speakerCenter unitKSC-SW10ExamplesThe following shows a typical connection for effective car stereo enjoyment. Connect your system by referring to the example.If there is no power control terminal in the center unit, con-nect the blue/white wire to the accessory line(ignition key switch ACC position line).Center unit(SUB WOOFER OUT,Non-fader output)Blue/WhiteYellow YellowCaution:Connect the black lead wire ground terminal directly with a screw to an unpaintedmetal part of the vehicle. Turning the power ON without connecting this terminal islinked to damage of the stereo system. Be sure to connect it.Also, painted metal panels etc., are not grounded and will not function correctly. Becareful.BatteryCar fuse box(Main fuse)Car fuse boxIgnition keyswitchFuse 10AIf buzzing noise is heard from thespeakers when the engine is running,attach a line noise filter (commerciallyavailable) to the power lead.RCA cord(Commerciallyavailable parts)9 RCA cordWhen the center unit output is a single RCA jack, use anRCA cord that converts the output into the two RCA jacksas shown above.The subwoofer output will be halved if the conversioncord is not used.REMOTELINE INPOWER/SPEAKERINPUTL RCaution:Under any circumstances, never ap-ply inputs to the hashed terminals Aand B simultaneously.Caution:Cover unused terminals with insula-tion tape to avoid short circuits.RCA cord (Commerciallyavailable parts) 9 RCA cord6 10-pin connector cord130.com.uaAutogood products internet store http://130.com.ua

/ 10

Related manuals for Kenwood KSC-SW10